Controlling the projector through a Lan environment
Lan Control Settings allow you to manage the projector from a computer using a web browser when the computer and the projector are properly connected to the same local area network.
Configuring the Lan Control Settings
If you are in a DHCP environment:
1.Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end to the RJ45 port.
2.Press MENU/EXIT and then press 
/ 
until the SYSTEM SETUP: Advanced menu is highlighted.
3.Press 
to highlight Lan Control Settings and press MODE/ENTER. The Lan Control Settings page displays.
4.Press 
to highlight Control By and press 
/ 
to select RJ45.
Network |
|
Network State | Disconnect |
DHCP | Off |
Projector IP Address | 0.0.0.0 |
Subnet Mask | 0.0.0.0 |
Default Gateway | 0.0.0.0 |
DNS | 0.0.0.0 |
Apply
Menu Back
5.Press 
to highlight DHCP and press 
/ 
to select On.
6.Press 
to highlight Apply and press MODE/ENTER.
7.
Default Gateway, and DNS Server settings will display. Note down the IP address displayed in the Projector IP Address row.
If the Projector IP Address still does not display, contact your ITS administrator.
English
Operation 43