Barco R9002327, R9002328 installation manual On cleaning

Page 9

SAFETY INSTRUCTIONS

SAFETYINSTRUCTIONS

c. If the product has been exposed to rain or water.

d. If the product does not operate normally when the operating instructions are followed. Note :

Adjust only those controls that are covered by the operating instructions since improper adjustment of the other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation.

e. If the product has been dropped or the cabinet has been damaged.

f. If the product exhibits a distinct change in performance, indicating a need for service.

Replacement parts - When replacement parts are required, be sure the service technician has used original BARCO replacement parts or authorized replacement parts which have the same characteristics as the BARCO original part. Unauthor- ized substitutions may result in degraded performance and reliability, fire, electric shock or other hazards. Unauthorized substitutions may void warranty.

Safety check - Upon completion of any service or repairs to this projector, ask the service technician to perform safety checks to determine that the projector is in proper

operating condition.

On cleaning

Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

-To keep the cabinet looking brand-new, periodically clean it with a soft cloth. Stubborn stains may be removed with a cloth lightly dampened with mild detergent

solution. Never use strong solvents, such as thinner or benzine, or abrasive cleaners, since these will damage the cabinet.

-To ensure the highest optical performance and resolution, the projection lenses are specially treated with an anti-reflective coating, therefore, avoid touching the lens. To remove dust on the lens, use a soft dry cloth. Do not use a damp cloth, detergent solution, or thinner.

On re-packing

Save the original shipping carton and packing material; they will come in handy if you ever have to ship your equipment. For maximum protection, re-pack your set as it was originally packed at the factory.

On illumination

In order to obtain the best quality for the projected image, it is essential that the ambient light which is allowed to fall on the screen be kept to an absolute minimum.

1-6

 

5975069ABARCOVISION708200498

 

Image 9
Contents Installationmanual Page Table of Contents Safety Instructions Installation Instructions Safetyinstructions Barcovision On safetyOn installation On cleaning Safetyinstructions Unpacking Dimensions Unpacking Projector dimensions Installation Guidelines What about ambient light ? EnvironmentInstallation Guidelines Where to install the projector? Installation Guidelines Fhlolqj Surmhfwru Urqwylhz Barco ceiling support Access to controls Scan adaptation Installation SET UPAccess to controls Installation SET UP Remote R GS B Video S-VIDEO Yujhqfh Horizontal scan inversion Service mode menu will be dis- played Projector set up menu will be displayed Password mode Projector SET UPFrqqhfwruv Projector Set UpSocket for strap Power Mains Connection Power mains cord connection Input power mains voltageFuses Switching on/off Installation Adjustments Entering the adjustment mode InstallationRandom Access Service Adjustment Guided Overview flow chart installation mode Access menu Installation mode start upRisk of Electrical Shock No User Adjustable Parts Inside Factory programmed password 0000 Adjusting the projector with the local keypad Scheimpfug adjustment Hqverowv /HQVEROWV /HQVEROWV Oxhohqv *UHHQOHQV 5HGOHQV Ruqhu Irfxvlqj Electrical focusing Raster Centering 233 CRT Projection Angle Adjustment CRT projection angle adjustmentProjection angle correctly aligned Red image coincides with the center CRT Alignment of the projector Ceiling mount kit for 700 projectors CM50 Appendix a Ceiling Mount KIT CM50G2 adjustment Appendix B G2 AdjustmentAppendix B G2 Adjustment Green G2 LED