Onkyo HT-RC370 instruction manual Controlling Other Components, Preprogrammed Remote Control Codes

Controlling Other Components

You can use the AV receiver’s remote controller to control your other AV components, including those made by other manufacturers. This section explains how to enter the remote control code for a component that you want to control: DVD, TV, CD, etc.

“Learning Commands” for learning commands directly from another component’s remote controller

(➔ page 70).

“Using Normal Macros” for programing ACTIVITIES to perform a sequence of remote control actions

(➔ page 71).

Preprogrammed Remote Control Codes

The following REMOTE MODE buttons are preprogrammed with remote control codes for controlling the components listed. You do not need to enter a remote control code to control these components.

For details on controlling these components, see the indicated pages.

BD/DVD Onkyo Blu-ray Disc player (➔ page 68) TV/CD Onkyo CD player (➔ page 68)

PORT Onkyo Universal Port Option (➔ page 65)

Looking up for Remote Control Code

You can look up for an appropriate remote control code from the on-screen setup menu.

Note

• This can only be carried out using the on-screen setup menu.

1	Press RECEIVER followed by SETUP.
	The main menu appears on-screen.
	Tip
	• If the main menu doesn’t appear, make sure the appropriate
	external input is selected on your TV.
2	Use q/wto select “Remote Controller Setup”, and
	then press ENTER.
3	Use q/wto select “Remote Mode Setup”, and then
	press ENTER.
4	Use q/wto select a remote mode, and then press
	ENTER.
	The menu of category selection appears.
5	Use q/wto select a category, and then press
	ENTER.

The panel for brand name input appears.

6 Use qwer/ / / to select a character, and then press

ENTER.

Repeat this step for the first three characters of the brand name.

When you have entered the 3rd character, select “Search” and press ENTER.

A list of brand names is retrieved.

If the desired brand name is not found:

Use rto select “Not Listed”, and then press

ENTER.

The panel for brand name input appears.

7 Use q/wto select a brand, and then press ENTER. A remote control code with its instructions are displayed. Follow the procedure.

8 If you can control the component, use q/wto select “OK”, and then press ENTER.

The “Remote Mode Setup” menu appears.

If you cannot control the component, use q/wto select “Try next code” and press ENTER.

The next code is displayed.

Entering Remote Control Codes

You’ll need to enter a code for each component that you want to control.

1 Look up the appropriate remote control code in the separate Remote Control Codes list.

The codes are organized by category (e.g., DVD player, TV, etc.).

2 While holding down the REMOTE MODE to which you want to assign a code, press and hold down DISPLAY (about 3 seconds).

The REMOTE MODE button lights.

Note

•Remote control codes cannot be entered for RECEIVER and ZONE 2.

•Only TV remote control codes can be entered for TV.

•Except for RECEIVER, TV and ZONE 2, remote control codes from any category can be assigned to the REMOTE MODE. However, these buttons also work as input selector buttons (➔ page 23), so choose a REMOTE MODE that corresponds with the input to which you connect your component. For example, if you connect your CD player to the CD input, choose TV/CD when entering its remote control code.

3 Within 30 seconds, use the number buttons to enter the 5-digit remote control code.

REMOTE MODE button flashes twice.

If the remote control code is not entered successfully, REMOTE MODE button will flash once slowly.

Note

•Though the provided remote control codes are correct at the time of printing, they are subject to change.

En

67