PYLE Audio PLVHR72 instruction manual Precautions

Page 4

Precautions

Please read this manual completely and carefully prior to attempt to install your new car video equipment. Install correctly, your new equipment will provide you with years of enjoyable and safe usage.

Installing this unit requires technical expertise. This unit should be installed by a qualified technician or service personnel. If you try to install this unit by yourself, do it properly, referring to the installation and wiring diagrams in this operating manual. Improper installation may result in fire or electric shock.

1.Do not operate this equipment while driving-safe driving should always be your highest priority.

2.Do not install components in areas which are susceptible to rain, moisture direct sunlight, extremely heat or cold, excessive dust, dirt or humidity.

3.Immediately unplug the power cord and send the monitor to your local dealer or service center as soon as possible:

a)If there is smoke or any peculiar odor present during used

b)If there is damage to any of the internal components

4.To avoid damage to the monitor and risk of electronic shock, do not permit any of this equipment to become damp or wet from water or liquid. If this does occur, immediately unplug the power cord and send the monitor to your local dealer or service center as soon as possible.

5.Do not attempt to repair, open or disassemble any of the components. Dangerous high voltages are present which may result in electric shock.

6.Use only a power source with DC12 volts car battery (negative ground).

7.Do not place or suspend objects on the power cord, as this may damage the cord.

8.Do not twist or place the power cord near any source of heat in the vehicle.

9.Do not attempt to repair a damaged, broken or faulty power cord. Replace it with a new one immediately.

10.Avoid dropping any metal objects or inflammable items into the monitor ventilation slots.

11.After the monitor is installed, do not arbitrarily pull it down or strike it. This may loose the mounting screws and cause it fall down.

12.Do not install this unit where:

a)it will obstruct the driver’s view.

b)it will obstruct the operation of the airbag system.

c)it will obstruct the operation of the vehicle, especially the steering wheel, shift lever, or brake pedal.

d)a diver or passengers may injure themselves when getting into or out of the car.

3

Image 4
Contents PLVHR72 Table of Contents No picture, no sound Good picture, but no sound Dolled lines or stripesPrecautions Control and layout for the remote control Control and layout for the monitorAccessories Connection Diagram Replacing the Remote ControlSteps For Installing Headrest with Shroud Setup workMeasurements Cut the headrestRoute the cable through the headrest Install the headrest shroudRemoval Steps For Installing Sun-visor with Shroud Cut the visorRoute the cable through the visor Install the sun-visor shroudInsert the monitor Rear side of headrest Front side of headrest MU ENT SEL MU ENTRET SEL ADJExit Save / Exit MU Exit Save / Exit SEL SET SEL MU ADJMakes color appear lighter or darker Monitor Remote SEL. MU SET. Exit RET Press Menu button 1 to set the OSD Language Select English Exit Save / Exit Information Source Av1 Format Ntsc HS 15.7 Khz VS 59.8Hz Exit Vcom Adjust Display Model Rotate Specifications Current Consumption 6 W Max Weight 154g