PYLE Audio PLVHR72 Route the cable through the headrest, Install the headrest shroud, Removal

Page 9

Route the cable through the headrest

Run the supplied cable through the opening

and out to the bottom of the headrest. If possible, conceal the wires with a shaft covering.

Connect the power, ground and video leads to test the MONITOR.

Before connecting the monitor, pull the connecting cable through the headrest shroud as shown in diagram. Place the headrest housing into the opening and secure with correct fasteners.

Install the headrest shroud

Pull the connecting cable through the center of the shroud as shown in diagram, and secure the headrest shroud with correct fasteners

Insert the monitor

Push to insert the monitor to the headrest shroud.

Removal

Insert the release key between the monitor and headrest shroud gap and pull it out to remove the monitor from headrest shroud.

8

Image 9
Contents PLVHR72 Table of Contents Dolled lines or stripes No picture, no sound Good picture, but no soundPrecautions Control and layout for the monitor Control and layout for the remote controlAccessories Replacing the Remote Control Connection DiagramSetup work Steps For Installing Headrest with ShroudMeasurements Cut the headrestInstall the headrest shroud Route the cable through the headrestRemoval Cut the visor Steps For Installing Sun-visor with ShroudInstall the sun-visor shroud Route the cable through the visorInsert the monitor Rear side of headrest Front side of headrest SEL MU ENT MU ENTSEL ADJ RETExit Save / Exit MU Exit Save / Exit SEL MU ADJ SEL SETMakes color appear lighter or darker Monitor Remote SEL. MU SET. Exit RET Press Menu button 1 to set the OSD Language Select English Exit Save / Exit Information Source Av1 Format Ntsc HS 15.7 Khz VS 59.8Hz Exit Vcom Adjust Display Model Rotate Current Consumption 6 W Max Weight 154g Specifications