PYLE Audio PLVHR72 instruction manual Steps For Installing Sun-visor with Shroud, Cut the visor

Page 10

Steps For Installing Sun-visor with Shroud

Setup work

Remove the visor and set it in an uncluttered work area. Pay appropriate precautions to ensure that it is not damaged during the installation.

CAUTION: make sure the screws are not long enough to go through the visor!

If you have any doubts about this type of installation, please consult your local mobile electronics retailer. Cutting and making holes in the visor will cause electronic damage which is expensive to repair.

Measurements

Press push on the headliner with your fingers to make sure there are no obstructions that would hinder

the installation. Use paper template to mark the area to be cut.

Cut the visor

Use an adjustable-depth blade, start your cut 1/4 inch inside one corner and cut diagonally across, stopping 1/4 inch in from the other corner. Repeat this procedure for the other two corners.

Remove foam & obstructions

Carefully peel off the material. Set the adjustable blade to one inch depth and cut around the edges of the hole, staying 1/4 inch inside the edge. Pull up one corner of the foam and use the blade to cut underneath. Remove small section at a time, ensure to be the uniform depth . Use a dremel or other appropriate tools to remove other obstructions. Insert the monitor to measure the fit and make adjustment if necessary.

9

Image 10
Contents PLVHR72 Table of Contents No picture, no sound Good picture, but no sound Dolled lines or stripesPrecautions Control and layout for the remote control Control and layout for the monitorAccessories Connection Diagram Replacing the Remote ControlMeasurements Steps For Installing Headrest with ShroudSetup work Cut the headrestRoute the cable through the headrest Install the headrest shroudRemoval Steps For Installing Sun-visor with Shroud Cut the visorRoute the cable through the visor Install the sun-visor shroudInsert the monitor Rear side of headrest Front side of headrest MU ENT SEL MU ENTRET SEL ADJExit Save / Exit MU Exit Save / Exit SEL SET SEL MU ADJMakes color appear lighter or darker Monitor Remote SEL. MU SET. Exit RET Press Menu button 1 to set the OSD Language Select English Exit Save / Exit Information Source Av1 Format Ntsc HS 15.7 Khz VS 59.8Hz Exit Vcom Adjust Display Model Rotate Specifications Current Consumption 6 W Max Weight 154g