PYLE Audio PLVHR72 Route the cable through the visor, Install the sun-visor shroud

Page 11

THIS SIDE UP

Route the cable through the visor

Run the supplied cable through the opening and out to the bottom of the visor. If possible, conceal the wires using a shaft covering. Connect the power, ground and video leads to test the MONITOR. Before connecting the monitor, pull the connecting cable assembly through the visor housing as shown in diagram. Place sun-visor shroud into the opening and secure it with correct fasteners.

Install the sun-visor shroud

Pull the connecting cable through the center of the housing as shown in diagram, and secure the sun-visor shroud with correct fasteners

Insert the monitor

Push to insert the monitor to the sun-visor shroud.

Removal

Insert the release key between the monitor and visor shroud gap and pull it out to remove the monitor from headrest shroud.

Oper ate your syst em in a saf e and legal manner

When oper ate a motor vehi cle, it shoul d always be your highest priority to maintain saf e driving habi ts.

It is illegal in many areas of most count ries to drive with TV or MONITOR on, when it is visible to the driver . Please check your local and state laws gover ning the use of MOBILE ENTER TAINMENT SYSTE M in your area.

10

Page 10 Page 12
Image 11
Page 10 Page 12
Contents PLVHR72 Table of Contents Dolled lines or stripes No picture, no sound Good picture, but no soundPrecautions Control and layout for the monitor Control and layout for the remote controlAccessories Replacing the Remote Control Connection DiagramCut the headrest Steps For Installing Headrest with ShroudSetup work MeasurementsRemoval Install the headrest shroudRoute the cable through the headrest Cut the visor Steps For Installing Sun-visor with ShroudInsert the monitor Install the sun-visor shroudRoute the cable through the visor Rear side of headrest Front side of headrest SEL MU ENT MU ENTExit Save / Exit SEL ADJRET MU Exit Save / Exit SEL MU ADJ SEL SETMakes color appear lighter or darker Monitor Remote SEL. MU SET. Exit RET Press Menu button 1 to set the OSD Language Select English Exit Save / Exit Information Source Av1 Format Ntsc HS 15.7 Khz VS 59.8Hz Exit Vcom Adjust Display Model Rotate Current Consumption 6 W Max Weight 154g Specifications
Top Page Image Contents