PYLE Audio PLVHR72 Steps For Installing Headrest with Shroud, Setup work, Measurements

Page 8

Steps For Installing Headrest with Shroud

Setup work

Remove the headrest and set it in an uncluttered work area. Pay the appropriate precautions to ensure that it is not damaged during the installation.

CAUTION: make sure the screws are not long enough to go through the headrest!

If you have any doubts about this type of installation, please consult your local mobile electronics retailer. Cutting and making holes in the headrest will cause electronic damage which is expensive to repair.

Measurements

Press the headrest with your fingers to make sure there are no obstructions that would hinder the installation. Use paper template to mark the area to be cut.

Cut the headrest

Use an adjustable-depth blade, start your cut 1/4 inch inside one corner and cut diagonally across, stopping 1/4 inch in from the other corner. Repeat this procedure for the other two corners.

Remove foam & obstructions

Carefully peel off the material. Set the adjustable blade to one inch depth and cut around the edges of the hole, staying 1/4 inch inside the edge. Pull up one corner of the foam and use the blade to cut underneath. Remove small section at a time and ensure to be the uniform depth. Use a dremel or other appropriate

tools to remove other obstructions. Insert the monitor to measure the fit and make adjustment if necessary

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents PLVHR72 Table of Contents No picture, no sound Good picture, but no sound Dolled lines or stripesPrecautions Control and layout for the remote control Control and layout for the monitorAccessories Connection Diagram Replacing the Remote ControlSteps For Installing Headrest with Shroud Setup workMeasurements Cut the headrestRemoval Install the headrest shroudRoute the cable through the headrest Steps For Installing Sun-visor with Shroud Cut the visorInsert the monitor Install the sun-visor shroudRoute the cable through the visor Rear side of headrest Front side of headrest MU ENT SEL MU ENTExit Save / Exit SEL ADJRET MU Exit Save / Exit SEL SET SEL MU ADJMakes color appear lighter or darker Monitor Remote SEL. MU SET. Exit RET Press Menu button 1 to set the OSD Language Select English Exit Save / Exit Information Source Av1 Format Ntsc HS 15.7 Khz VS 59.8Hz Exit Vcom Adjust Display Model Rotate Specifications Current Consumption 6 W Max Weight 154g
Top Page Image Contents