Onkyo TXSR307 Precautions, Power, Preventing Hearing Loss Caution, FCC Information for User

Page 3

Precautions

1.Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal without the permission of the copyright holder.

2.AC Fuse—The AC fuse inside the unit is not user- serviceable. If you cannot turn on the unit, contact your Onkyo dealer.

3.Care—Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the unit immediately afterwards with a clean cloth. Don’t use abrasive cloths, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering.

4.Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable (easily accessible) at all times.

For North American model

Pressing the [ON/STANDBY] button to select Standby mode does not fully shutdown the unit. If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet.

5.Preventing Hearing Loss Caution

Excessive sound pressure from earphones and headphones can cause hearing loss.

6.Batteries and Heat Exposure Warning

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat as sunshine, fire or the like.

7.Never Touch this Unit with Wet Hands—Never handle this unit or its power cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer.

8.Handling Notes

•If you need to transport this unit, use the original packaging to pack it how it was when you originally bought it.

•Do not leave rubber or plastic items on this unit for a long time, because they may leave marks on the case.

•This unit’s top and rear panels may get warm after prolonged use. This is normal.

•If you do not use this unit for a long time, it may not work properly the next time you turn it on, so be sure to use it occasionally.

For U.S. models

FCC Information for User

CAUTION:

The user changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit dif- ferent from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV techni- cian for help.

For Canadian Models

NOTE: THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle pour les Canadien

REMARQUE: CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA.

Sur les modèles dont la fiche est polarisée:

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Others Basic Operations Using the Listening ModesIntroduction ConnectionAvis Important Safety InstructionsBatteries and Heat Exposure Warning PrecautionsPower Preventing Hearing Loss CautionSupplied Accessories PrecautionsHow to mount the AC plug Contents Connections FeaturesAmplifier ProcessingFront Panel Front & Rear PanelsDisplay Front & Rear PanelsRear Panel VCR/DVR IN/OUT DVD/BDSubwoofer PRE OUT Controlling the AV receiver Remote ControllerRemote Controller Installing the BatteriesAiming the Remote Controller Speaker Set B Sub Room Enjoying Home TheaterSpeaker Sets a and B Speaker Set a Main RoomConnecting Your Speakers Connecting the AV ReceiverStrip 3/8 10 mm Connecting the AV ReceiverConnecting the Speaker Cables Strip about 5/8Attach the FM antenna, as shown North American Model Connecting AntennaConnecting the Indoor FM Antenna Connecting the AM Loop AntennaConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaUsing a TV/FM Antenna Splitter About AV Connections Optical Digital Jacks AV Connection Color CodingAV Cables and Jacks Audio Connection Formats Connecting Audio and Video Signals to the AV receiverWhich Connections Should I Use? Video Connection FormatsPass-Thru Connecting Components with HdmiAbout Hdmi About Copyright ProtectionTip Making Hdmi ConnectionsHint Connecting a TV or ProjectorVideo Connection Audio ConnectionConnecting a DVD/BD player Connecting a VCR or DVR for Playback Make the audio connection a Connecting a VCR or DVR for RecordingSatellite, cable, set-top box, etc Connecting a Camcorder, Game Console, or Other Device Connecting a Portable Audio playerMake the video connection a Make the audio connection a CD Player or Turntable MM with Built-in Phono Preamp Step Connecting a CD Player or TurntableConnecting a Cassette, CDR, MiniDisc, or DAT Recorder Connecting an RI Dock If Your iPod Supports VideoIf Your iPod Doesn’t Support Video Direct Change Connecting Onkyo u ComponentsConnecting the Power Cord Auto Power On/StandbyTurning On the AV receiver Turning On and StandbyUp and Running in a Few Easy Steps First Time Setup Audyssey 2EQ Room Correction and Speaker SetupMeasurement Positions Using Audyssey 2EQ First Time SetupUsing a Powered Subwoofer Error MessagesTo Retry the Room Correction and Speaker Setup Changing the Speaker Settings ManuallyDigital Input Setup Component Video Input SetupChanging the Input Display Start playback on the source component Select a listening mode and enjoyBasic Operations Basic AV receiver OperationMuting the AV receiver Setting the Display BrightnessUsing the Sleep Timer Basic OperationsBass 7Using HeadphonesAdjusting the Bass & Treble Displaying Source InformationUsing the Music Optimizer Specifying the Digital Signal FormatAuto default Buttons to select AM/FM Frequency Step Setup not European modelsListening to the Radio Use the Left and Right e/rUse the AM or FM input selector button to select AM or FM Tuning into AM/FM Radio StationsListening to the Radio Listening to AM/FM StationsDisplaying AM/FM Radio Information Presetting AM/FM Stations Deleting PresetsSelecting Presets RDS Program Types PTY Using RDS European models onlyDisplaying Radio Text RT Finding Stations by Type PTYListening to Traffic News TP Recording Recording from Different AV SourcesRecording the Input Source Stereo button Using the Listening ModesSelecting the Listening Modes MOVIE/TV button Game buttonUsing the Listening Modes Listening Modes Available for Each Source FormatMono/Multiplex Sources Stereo Source DTS Multichannel SourcesOnkyo Original DSP Modes About the Listening ModesAdvanced Setup Common Procedures in Setup MenuSpeaker Settings Sp Distance Speaker Distance Advanced SetupUse the Down w button to select Ch, and then use the Left Equalizer Equalizer SettingsLeft and Right e/ r buttons to adjust the level at that Level Cal Speaker Levels CalibrationAudio Adjust Settings Audio Adjust Multiplex/Mono SettingsPLII/Neo6 Settings Dynamic EQ Off Audyssey Dynamic EQ off Audyssey SettingsDyn Vol Dynamic Volume Theater-Dimensional SettingUse the number buttons to enter ID 1, 2, or Hardware SetupHardware Remote ID While holding down the Receiver button, press and hold downUsing the Audio Settings Sync Audyssey Dynamic VolumeMusic Optimizer Speaker LevelsPreprogrammed Remote Control Codes Entering Remote Control CodesControlling Other Components Controlling Other Components Resetting the Remote ControllerRemote Control Codes for Onkyo Components Connected via u Resetting the Remote Mode ButtonsControlling a DVD Player Controlling a CD Player, CD Recorder, or MD Player Cancels functions and clears entered numbersControlling an RI Dock Used with the shuffle function Troubleshooting Troubleshooting How do I change the language of a multiplex source Sound changes when I connect my headphonesCan’t control other components Can’t recordTuner Section SpecificationsAmplifier Section Video Section3 4 4 9 2 1 a
Top Page Image Contents