Onkyo TXSR307 Using the Music Optimizer, Specifying the Digital Signal Format, Auto default

Basic Operations—Continued

Using the Music Optimizer

The Music Optimizer function enhances the sound quality of compressed music files. Use it with music files that use “lossy” compression, such as MP3.

To turn the Music Optimizer “On” or “Off”, use the AV receiver’s [MUSIC OPTIMIZER] button.

Off: Music Optimizer off (default).

On: Music Optimizer on.

Tip:

This procedure can also be performed on the remote controller by using [AUDIO] button (see page 61).

Note:

The Music Optimizer function only works with PCM digital audio input signals with a sampling rate below 48 kHz and analog audio input signals. The Music Opti- mizer is disabled when the Direct listening mode is selected.

Specifying the Digital Signal Format

The following table shows the display indicator for each digital signal format.

Format	Display
Dolby Digital
DTS
PCM		PCM

Normally, the AV receiver detects the format of digital input signals automatically. However, if you experience either of the following issues when playing PCM or DTS sources, you can specify the signal format manually.

•If the beginnings of tracks from a PCM source are cut off, try the PCM setting.

•If noise is produced when fast forwarding or rewinding a DTS CD, try the DTS setting.

e, r

AUDIO

1

2

Press and hold [AUDIO] button for about 8 seconds.

While “Auto” is displayed (about 3 seconds), use the Left and Right [e]/[r] buttons to select:

PCM, DTS, or Auto.

PCM:

Only 2-channel PCM format input signals will be heard. If the input signal is not PCM, the PCM indicator will flash and there will be no sound.

DTS:

Only DTS format input signals will be heard. If the input signal is not DTS, the DTS indicator will flash and there will be no sound.

Auto (default):

The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead.

41