Advanced Setup—Continued
5. Level Cal (Speaker Levels Calibration)
These settings are set automatically by the Audyssey 2EQ™ Room Correction and Speaker Setup function (see page 33).
You can set the volume level of each speaker so that all speakers can be heard equally at the listening position. A pink noise test tone is output by the front left speaker.
Notes:
•Speakers that you set to “No” or “None” in the “3. Sp Config” (page 54) do not output the test tone.
•The speaker levels cannot be adjusted while a pair of headphones is connected, speaker set B is on, or the AV receiver is muted.
Left, Center, Right, SurrRight, SurrLeft, Subwoofer
The levels can be adjusted from
6. Equalizer (Equalizer Settings)
These settings are set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 33). Here you can adjust the tone of individual speakers. To set the volume of individual speakers, see page 56.
Notes:
•You can select: “63Hz”, “250Hz”, “1000Hz”, “4000Hz”, or “16000Hz”. And for the subwoofer, “25Hz”, “40Hz”, “63Hz”, “100Hz”, or “160Hz”.
•While the Direct listening mode is selected, the equalizer settings have no effect.
•The equalizer setting cannot be changed while a pair of headphones is connected, or speaker set B is on.
EQ | Manual: You can adjust the equalizer for each speaker manually. If you select “Manual”, | ||||
|
| continue with this procedure. | |||
|
| Select a frequency | |||
|
|
|
|
| |
|
| 1 | Use the Down [w] button to select “Ch”, and then use the Left and | ||
|
|
| Right [e]/[r] buttons to select a speaker. | ||
|
| 2 | Use the Up and Down [q]/[w] buttons to select a frequency. Use | ||
|
|
| the Left and Right [e]/[r] buttons to adjust the level at that | ||
|
|
| frequency. | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| The volume at each frequency can be adjusted from | ||
|
|
| Tip: | ||
|
|
| Low frequencies (e.g., 63Hz) affect bass sounds; high frequencies (e.g., | ||
|
|
| 16000Hz) affect treble sounds. | ||
|
|
|
|
| |
|
| 3 | Use the Up [q] button to select “Ch”, and then use the Left and |
Right [e]/[r] buttons to select another speaker.
Repeat steps 1 and 2 for each speaker.
Speakers that you set to “No” or “None” in the “3. Sp Config” (page 54) do not output the test tone.
Audyssey: The tone for each speaker is set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function. Be sure to select this setting after having performed the Room Correction and Speaker Setup. “Dynamic EQ” and “Dyn Vol” become available (see page 58).
Off: Tone off, response flat (default).
56