Onkyo TX-SR505E, SR575 First Time Setup, Automatic Speaker Setup Audyssey 2EQ, Measurement Points

First Time Setup

This section explains the settings that you need to make before using the AV receiver for the very first time.

Automatic Speaker Setup (Audyssey 2EQ)

With the supplied speaker setup microphone, the Audyssey 2EQ function can measure the number of speakers connected, their sizes, crossover frequencies, and distances from the listening position, and then calcu- late the optimal speaker settings for your listening envi- ronment.

Before using this function, connect and position all of your speakers.

If any of your speakers are 4 ohms, change the min- imum speaker impedance setting below before run- ning the automatic speaker setup (not north American model).

Measurement Points

To create a listening area in which several people can enjoy home theater simultaneously, the Audyssey 2EQ function takes measurements at three points within the listening area:

AFirst measurement point

This is the center point of the listening area, or the listening position if it’s just one person.

BSecond measurement point

The right side of the listening area.

CThird measurement point

The left side of the listening area.

The distances between points 1 and 2 and points 1 and 3 must be at least 1 meter.

From the examples below, choose the listening area that best matches yours and place the microphone accord- ingly when prompted.

Minimum Speaker Impedance Setup (not North American model)

If the impedance of any of the connected speakers is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms.

Note:

Before you change this setting, turn down the volume.

1	Press the [RECEIVER] button, followed
	by the remote controller’s [SETUP] but-
	ton.
2	Use the Up and Down [	]/[	] buttons
	to select “0. Hardware Setup,” and then
	press [ENTER].
3	Use the Left and Right [	]/[	] buttons
	to select the setting for “Impedance.”

4 ohms: Select if the impedance of any con- nected speaker is 4 ohms or more but less than 6.

6 ohms: Select if the impedances of all con- nected speakers are between 6 and 16 ohms.

4	Press the [SETUP] button.
	Setup closes.

TV TV

TV TV

TV TV

:Listening area

: Listening position

TV

TV

TV

35