Display, Video Setup | Beaumont Products MPEG - 2, MPEG

V B R I C K E T H E R N E T V S E T T O P B O X U S E R S G U I D E

V E R S I O N 3 . 6 . 9

Video

These settings enable or change these and other selections:

Boot Mode – There are three supported modes:

MCS – If the installation includes the EtherneTV Media Control Server, this selection should be set.

Local – If the installation is for an EtheneTV Set Top Box connected directy to a network, this selection should be set.

Local-Fullscreen – If the installation is for an EtherneTV Set Top Box tuned to one channel, this selecton should be set.

NOTE: If Local-Fullscreen mode is selected, a Receive Address must also be entered.

MCS Location – If the set top box is part of an installation that includes an MCS, enter the IP address of the MCS server here.

Main Volume – Change the volume level if desired. Line 1 Volume – Change the volume level if desired.

Receive Address – The receive address or URL of the desired video.

NOTE: A Receive Address must be entered if Local-Full Stream mode is selected.

There are no user configurable parameters in the Display: General and the Display: Resolution settings.

C O P Y R I G H T V B R I C K S Y S T E M S

P A G E 1 1

N O V E M B E R 1 0 , 2 0 0 3