English

The Tower Configuration allows the user to install the UPS in the up-right position next to the tower computer. There is a tower bracket kit available for the UPS. Use CAUTION, the UPS is extremely heavy. Once the location of the UPS has been determined, lay the UPS down flat on a desk or a table. Position the UPS so that the tower brackets will slide on the unit. Locate the mounting bracket screw holes on the side panel of the unit, there are four mounting bracket screw holes at the front of the unit and four at the rear of the unit. Align the brackets with the mounting bracket screw holes and attach with the retaining screws. Stand the UPS up on the tower brackets. Slide the UPS and the tower computer together. NOTE: Verify that the UPS is stable. The face plate can be rotated to read in the up-right position. Pull the front panel off the UPS. On the backside of the front panel, there are four tabs holding the face plate to the front panel. Push the four tabs inward and the face plate will pop out. Position the face plate so that it reads in the up-right position. Reinstall the front panel on the UPS. Now the UPS is ready for the normal start-up procedure.