3M™ Micro Professional Projector MPro110
Troubleshooting
Problem | Cause | Solution |
Image is fuzzy | Place projector | |
| side of limits. Image not focused. | from wall. Turn focus to sharpen |
|
| image. |
Does not run on battery power | Battery not charged. | Plug in AC adapter and turn |
| Battery needs replacement. | power switch Off to charge bat- |
|
| tery. Replace battery if it will not |
|
| hold a charge. |
Blank image | Power is off. | Turn projector ON. Input source |
| Projector in Power Saver Mode. | must be powered ON and sending |
|
| an input signal. |
LED flashing red | Battery is low. | Plug in AC adapter and turn |
|
| power switch Off to charge |
|
| battery. |
LED is green | Projector in Power Saver Mode. | Projected images returns when |
|
| input signal resumes. |
LED is orange | Battery is charging. | LED is orange during charging |
|
| and goes off when battery is fully |
|
| charged. |
Video or VGA icon is flashing | No input signal is detected by | Turn on power for input source. |
| projector. |
|
Video/VGA icons alternate | No input cable is detected. | Connect input cable and power |
flashing |
| on input source. |
Operator’s Guide
© 2008 3M. All Rights Reserved. | 13 |