3M MP8747, MP8746 manual Remote Control Transmitter Identification, Standby/On

Section 2: Product Description

Remote Control Transmitter Identification

Use the remote control transmitter within a distance of approximately 3 meters (or 9.8 feet) from the sensor of the front of the projector, and within a range of 30° to the left and right. Strong light and obstacles may interfere with operation of the remote control transmitter.

STANDBY/ON

Press STANDBY/ON button to begin projection mode (lamp on) or press and hold button for one second to switch to standby mode (lamp off).

STANDBY/ON VIDEO

LASER

		VIDEO and RGB
	RGB	Press to select the input source. Press again
BLANK		to select the next source.

BLANK

Press to turn ON/OFF the screen blanking function.

DISK PAD

Press to operate the mouse shift function and left-click function.

*AUTO

Press to make projector automatically
adjust 4 items (V. POSIT, H. POSIT, H.
PHASE, and H. SIZE) for RGB input signal.
(Please see note at bottom right.)	AUTO

LASER

Press to turn ON/OFF laser beam pointer.

MOUSE / RIGHT

Press to click the right mouse button.

*POSITION

Press this and any menu directional arrows for corresponding movement of the picture (with RGB signal only).

MENU

Press to turn ON/OFF the menu screen display.

MENU directional arrows

Press to select menu items when the menu screen is displayed.

Press to operate the mouse shift function.

MENUPOSITION

MENU SELECT

RESET

RESET

Press to return a displayed menu item to its default setting.

Press to click right mouse button.

Press after scrolling with POSITION to return picture to original position.

*FREEZE

Press to turn ON/OFF the freeze (still) image display.

After the POSITION button has been pressed, press these buttons to move the picture upward, downward, and to the left

and right.

*MENU SELECT

Press to display individual menu items. Can also be used to click the left mouse function.

*MAGNIFY

Press to magnify the displayed image. Press (+) to enlarge the center of the image. Press again to enlarge up to 4x magnification. Press (-) to reduce display magnification. (Can also be used with POSITION to select image area to be

magnified.)

VOLUME and MUTE

Pressing these at the same time will operate the page-up or page-down function of the USB mouse.

	FREEZE	VOLUME
		Press to adjust loudness of sound.
	VOLUME	MUTE
MAGNIFY		Press to stop audio output. Press again to
	OFF	resume audio output.
	MUTE	TIMER
		Press to turn ON/OFF the Timer on the Menu
		screen. (Timer cannot be displayed during
	TIMER	Freeze function.)
			AUTO ADJUST Notes:
			Requires several tens of
			seconds.
			May not operate correctly in
			some cases, depending on
			the connected computer and
			its signal and type of image.
			Execute auto adjust with
			display of the running
*This button will not function if the			application set at maximum.
			After auto adjust, image may
messages “NO INPUT IS DETECTED”
			be slightly darker due to
or “SYNC IS OUT OF RANGE” are displayed.
			automatic adjustment of
			signal level.

Figure 2.4 Basic Remote Control Transmitter

12 3M™ Personal Projector MP8746/MP8747 © 3M IPC 2000