3M S10 manual Signal Searching, Selecting The Aspect Ratio, Temporarily Blanking The Screen

Operating (continued)

Signal Searching

	STANBY/ON
VIDEO	RGB SEARCH
ASPECT	AUTO BLANK
MAGNIFY	VOLUME
ON
	MUTE
OFF
FREEZE	KEYSTONE

1	Press the SEARCH button.
	Cycle through input signals, displaying the images of retrieved signals. If
	no signal is found, returns to the signal that was selected before the search
	was begun.
	rgb	video	s-video
			SEARCH
		component video

NOTE • May not function properly with some input signals.

• The signal searching function takes about 10 seconds to display an image.

Selecting The Aspect Ratio

	STANBY/ON
VIDEO	RGB SEARCH
ASPECT	AUTO BLANK
MAGNIFY	VOLUME
ON
	MUTE
OFF
FREEZE	KEYSTONE
POSITION	MENU
	ENTER
ESC	RESET

1 Press the ASPECT button.
RGB input	ASPECT

4:3 16:9 15:9 32:15

•At a RGB input, selecting an aspect ratio may display the message “SYNC IS OUT OF RANGE”. In this case, please select one of other aspect ratios.

VIDEO, S-VIDEO, COMPONENT VIDEO input

4:3 16:9 WIDE ZOOM

•At a COMPONENT VIDEO input of 16:9 Hi-Vision of 1125i (1035i/1080i)/750p, only 16:9 can be selected.

•When the 4:3 is selected under the SCREEN TYPE item of the OPTION menu. WIDE and ZOOM cannot be selected.

Temporarily Blanking The Screen

	STANBY/ON
VIDEO	RGB SEARCH
ASPECT	AUTO BLANK
MAGNIFY	VOLUME
ON

1	Press the BLANK button.
	The input signal screen is shut off, and a blank screen appears. You can
	set the blank screen using the menu (from the SCREEN menu, BLANK
	select BLANK).
	Press the BLANK button again to remove the blank screen,
	and return to the input signal screen.

NOTE • The temporarily blanking function will automatically finish if either the STANDBY/ON, SEARCH, RGB, VIDEO, FREEZE, AUTO, VOLUME, MUTE, POSITION or MENU button of remote control is pressed, or if a button of projector is pressed, or if there is a change in the input signal’s state.

21