Onkyo TXNR525 instruction manual En-22, Enter

1	Turn on the AV receiver and the connected TV.
	On the TV, select the input to which the AV
	receiver is connected.
2	Set the speaker setup microphone at the Main

Listening Position a, and connect it to the

SETUP MIC jack. SETUP MIC jack

Speaker setup microphone

The speaker setting menu appears.

Note

•The on-screen menus appear only on a TV that is connected to HDMI OUT. If your TV is connected to other video outputs, use the AV receiver’s display when changing settings.

3 When you’ve finished making the settings, press ENTER.

MultEQ: Auto Setup	Audyssey
Subwoofer	Yes

Perform the “4. Sp Config (Speaker Configuration)” according to your speaker configuration:

–Subwoofer (➔ page 46)

If you use a powered subwoofer(s), go to step 4. If not, go to step 5.

4 Adjust the subwoofer volume level to 75 dB, and then press ENTER.

Test tones are played through the subwoofer. Use the volume control on the subwoofer.

Note

•If your subwoofer does not have a volume control, disregard the displayed level and press ENTER to proceed to the next step.

•If you set the subwoofer’s volume control to its maximum and the level displayed is lower than 75 dB, leave the subwoofer’s volume control at its maximum and press ENTER to proceed to the next step.

5 Use q/wto select “Audyssey Quick Start” or “Audyssey MultEQ Full Calibration”, and then press ENTER.

6 Press ENTER.

Audyssey MultEQ® Room Correction and Speaker Setup starts.

Test tones are played through each speaker as Audyssey MultEQ Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone.

Do not disconnect the speaker setup microphone during Audyssey MultEQ Room Correction and Speaker Setup, unless you want to cancel the setup.

If you select “Audyssey Quick Start”, you will go to step 9.

7 Place the speaker setup microphone at the next position, and then press ENTER. Audyssey MultEQ performs more measurements. This takes a few minutes.

8 When prompted, repeat step 7.

En-22

Turning On & Basic Operations

9 Use q/wto select an option, and then press

ENTER.

	MultEQ: Auto Setup		Audyssey
	<- Review Speaker Configuration ->
	Subwoofer	:	Yes
	Front	:	Small
	Center	:	Small
	Surround	:	Small
	Crossover	:	100Hz
	Save
	Cancel
The options are:
`Save:

Save the calculated settings and exit

Audyssey MultEQ Room Correction and

Speaker Setup.

`Cancel:

Cancel Audyssey MultEQ Room Correction and Speaker Setup.

Tip

•You can view the calculated settings for the speaker configuration, speaker distances, and speaker levels by using e/r.

10Use q/wto select a target, and use e/rto change the setting.

After the results of Audyssey MultEQ have been saved, the menu will display the “Audyssey” (➔ page 49), “Dynamic EQ” (➔ page 49), “Dynamic Volume” (➔ page 50) settings.

Note

•When “Audyssey Quick Start” has been used for measurement, “Audyssey” cannot be selected.

•These settings are applied to all input selectors.

11Press ENTER.

12Disconnect the speaker setup microphone.