Onkyo TXNR525 instruction manual En-39

Displaying Source Information

You can display various information about the current input source as follows.

1 Press RECEIVER once followed by DISPLAY repeatedly to cycle through the available information.

Tip

•Alternatively, you can use DISPLAY on the AV receiver.

The following information can be typically displayed.

Input source & volume*1

Listening mode

Signal format*2

Sampling frequency*2

*1 When AM or FM radio is used, the band, preset number, and frequency are displayed.

*2 If the input signal is digital, the signal format is displayed. Information is displayed for about three seconds, then the previously displayed information reappears.

Using the Sleep Timer

With the sleep timer, you can set the AV receiver to turn off automatically after a specified period.

1 Press RECEIVER once followed by SLEEP repeatedly to select the required sleep time.

The sleep time can be set from 90 to 10 minutes in 10 minute steps.

The SLEEP indicator lights on the AV receiver’s display when the sleep timer has been set. The specified sleep time appears for about 5 seconds, then the previous display reappears.

Tip

•If you need to cancel the sleep timer, press SLEEP repeatedly until the SLEEP indicator goes off.

•To check the time remaining until the AV receiver sleeps, press SLEEP. Note that if you press again on SLEEP as the time being displayed is 10 minutes or less, the sleep timer will go off.

Setting the Display Brightness

You can adjust the brightness of the AV receiver’s display.

1 Press RECEIVER once followed by DIMMER repeatedly to switch between: normal, dim, or dimmer brightness.

Tip

•(North American and Taiwanese models) Alternatively, you can use DIMMER on the AV receiver.

Playback

Changing the Input Display

When you connect an u-capable Onkyo component, you must configure the input display so that ucan work properly.

1 Change the name of the input selector to “DOCK” or “TAPE”.

Tip

•See “Name” in “8. Source Setup” for changing the name (➔ page 50).

Note

•“DOCK” and “TAPE” cannot be selected for the input selector at the same time.

•Enter the appropriate remote control code before using the remote controller for the first time (➔ page 58).

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.

1 Press RECEIVER followed by MUTING.

The output is muted and the MUTING indicator flashes on the AV receiver’s display.

Tip

•To unmute, press MUTING again or adjust the volume.

•Muting is automatically cancelled when the AV receiver is set to standby.

En-39