Onkyo TXNR525 instruction manual En-47, Sp Distance Speaker Distance

■Front

`Small:

`Large:

Select based on the cone diameter.

Note

•If the “Subwoofer” setting is set to “No”, this setting is fixed to “Large”.

■Center*1, Surround*1

`Small:

`Large:

Select based on the cone diameter.

`None

Note

*1 If the “Front” setting is set to “Small”, the “Large” option cannot be selected.

■Crossover (Crossover Frequency)

This setting is advantageous for the speakers that you specified as “Small” in “4. Sp Config (Speaker Configuration)” (➔ page 46). To get the best bass performance from your speaker system, you need to set the crossover frequency according to the size and frequency response of your speakers.

`40Hz, 50Hz, 60Hz, 70Hz, 80Hz, 90Hz, 100Hz, 120Hz, 150Hz, 200Hz

Use the diameter of the smallest speaker in your system when choosing the crossover frequency.

Speaker cone diameter	Crossover frequency
Over 8 in. (20 cm)	40/50/60 Hz*
6-1/2 to 8 in. (16 to 20 cm)	70/80/90 Hz*
5-1/4 to 6-1/2 in. (13 to 16 cm)	100 Hz
3-1/2 to 5-1/4 in. (9 to 13 cm)	120 Hz
Under 3-1/2 in. (9 cm)	150/200 Hz*

*Choose the setting matching your speaker.

Note

•For a more accurate setting, look up the frequency response in the manuals supplied with your speakers and set accordingly.

•Choose a higher crossover frequency if you want more sound from your subwoofer.

■Double Bass

This setting is NOT set automatically by Audyssey MultEQ® Room Correction and Speaker Setup function (➔ page 21).

`On

`Off

Turn this setting on to boost bass output by feeding bass sounds from the front left, right, and center channels to the subwoofer.

Note

•When the “Subwoofer” setting is set to “No” or the “Front” setting to “Small”, this setting is fixed to “Off” (➔ page 46).

•This setting is set to “On” automatically when the

“Subwoofer” and “Front” settings are set for the first time to “Yes” and “Large” respectively.

Advanced Operations

5. Sp Distance (Speaker Distance)

This setting is set automatically by

Audyssey MultEQ Room Correction and Speaker Setup function (➔ page 21).

Here you can specify the distance from each speaker to the listening position so that the sound from each speaker arrives at the listener’s ears as the sound designer intended.

Note

•These settings are not available in either of the following cases:

–A pair of headphones is connected.

–The “Audio TV Out” setting is set to “On” (➔ page 53).

–“HDMI CEC (RIHD)” is set to “On” (➔ page 52) and you’re listening through your TV speakers.

■Unit `feet:

Distances can be set in feet. Range: 1ft to 30ft in 1 foot steps.

`meters:

Distances can be set in meters. Range: 0.3m to 9.0m in 0.3 meter steps.

(The default setting varies from country to country.)

■Left, Center, Right, Surround Right, Surround Left, Subwoofer

`Specify the distance from each speaker to your listening position.

Note

•Speakers that you set to “No” or “None” in the “4. Sp Config (Speaker Configuration)” (➔ page 46) cannot be selected.

En-47

Operating procedure (➔ page 44)