Onkyo TX-SR8360, TX-SR603/603E Speaker Setup, AM Frequency Step Setup some models only

First Time Setup—Continued

AM Frequency Step Setup (some models only)

Here you can specify the AM frequency step used in your area. When this setting is changed, all radio presets are deleted.

1	Press the [RECEIVER] button fol-
RECEIVER	lowed by the [SETUP] button.
	The main menu appears onscreen.

2	Use the Up and Down [ ]/[ ]
	buttons to select “0. Initial
ENTER	Setup,” and then press [ENTER].
	The Initial Setup menu appears.

ENTER

3 Use the Up and Down []/[ ] buttons to select “i. AM Freq Step,” and then use the Left and

ENTER

Right []/[ ] buttons to select: 10 kHz: Select if 10 kHz steps are

used in your area.

9 kHz: Select if 9 kHz steps are used in your area.

4	Press the [SETUP] button.
	The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Speaker Setup

Some of the settings in this section are set automatically by the Automatic Speaker Setup function (see page 39). Here you can check the settings made by the Automatic Speaker Setup function, or set them manually, which is useful if you change one of the connected speakers after using the Automatic Speaker Setup function.

Speaker Configuration

This setting is set automatically by the Automatic Speaker Setup function (see page 39).

Here you can specify which speakers are connected and their individual sizes.

For speakers with a cone diameter over 6-1/2 inches (16 cm), specify large, and for those with a diameter below this, specify small.

Cone diameter

1

2

2–10

1, 11

1	Press the [RECEIVER] button fol-
RECEIVER	lowed by the [SETUP] button.
	The main menu appears onscreen.

46