Onkyo TX-SR8360 Using the Tuner, Listening to the Radio, Tuning into Radio Stations

Basic Operations—Continued

Using the Tuner

With the built-in tuner you can enjoy AM and FM radio stations. You can store your favorite stations as presets for quick selection.

Listening to the Radio

1		Use the [TUNER] input selector
	TUNER	button to select either AM or FM.
		In this example, FM has been selected.
		Each time you press the [TUNER] but-
		ton, the input source changes between
		AM and FM.
			Band	Frequency
		(Actual display depends on country)

Tuning into Radio Stations

■Manual Tuning Mode

1 TUNING MODE	Press the [TUNING MODE] but-
	ton so that the AUTO indicator
	disappears from the display.
2TUNING	Press and hold the TUNING Up or
	Down [ ]/[ ] button.
	The frequency stops changing when
	you release the button.
	Press the buttons repeatedly to change
	the frequency one step at a time.

The North American model changes FM frequency in

0.2MHz steps, 10 kHz steps for AM. For other models it’s 0.05 MHz steps for FM and 9 kHz steps for AM. In Manual Tuning mode, FM stations will be in mono.

Tuning into weak FM stereo stations

If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the station in mono.

1 2

■Auto Tuning Mode

1 TUNING MODE	Press the [TUNING MODE] but-
	ton so that the AUTO indicator
	appears on the display.
2TUNING	Press the TUNING Up or Down
	[ ]/[ ] button.
	Searching stops when a station is
	found.

When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator appears on the display, as shown.

TUNED AUTO

FM STEREO

56