Lamp replacement
This projector is equipped with a lamp to project images. This lamp is a consumable. It may burn out or its brightness may decrease during use. In such cases, replace the lamp with a new one as soon as possible. Be sure to replace the lamp with a new lamp separately sold that is exclusive to this projector. Contact your dealer for purchase of the lamp.
Spare lamp for XD550U/XD560U/WD570U:
Caution:
•Do not remove the lamp immediately after using the projector. You may get burned because the lamp is very hot after use.
•Before replacing the lamp, press the POWER button to turn off the lamp and wait for two minutes for lamp to cool down. Unplug the power cord from wall outlet and wait one hour for the lamp to cool down completely.
•Do not remove the lamp except for replacement.
Careless handling can cause injury or fire.
•Do not touch the lamp directly. It may break and cause injury or burn.
•Be sure not to drop the lamp lid screw into the projector. Also be sure not to put metal or any flammable objects inside because it may cause fire or electric shock. If any objects should fall inside, unplug and contact your dealer.
•Install the lamp securely to prevent failure and fire.
•If the lamp should break, small glass fragments may fall out through the grilles and some may remain inside of the projector or the lamp box. When taking the lamp box out, be sure to turn over the projector and hold the handle of the lamp box to avoid injury due to the glass fragments.
•If the lamp should break, never shake the lamp box or hold it in front of your face after removing it. The glass fragments may fall out and cause injury to your eyes.
•When removing the lamp from the
•Be sure to use the lamp dedicated to this projector,
A) When the projector is placed on the table
Make sure that the projector is securely held in place.
1.Remove the cover (a) of the screw fixing the lamp cover with a fingernail. If it is difficult to remove it with a fingernail, use a finetipped tool such as flathead screwdriver.
(a)
3.Loosen the two screws (d) of the lamp unit, and then pull out the lamp unit (f) by the handle (e).
(e)
(d)
(f)
Caution:
•When replacing the lamp, do not loosen the screws other than two screws (d). It may cause the failure of projector.
•Pull the lamp unit out of the projector slowly.
If it is pulled out quickly, the lamp may break, scattering glass fragments.
•Do not spill liquid on the removed lamp unit or do not place it near any flammable object or where children can reach to prevent injuries or fire.
4.Insert the new lamp unit, and secure it with two screws firmly.
5.Secure the lamp cover with screw (b) back again, and mount the cover (a).
Caution:
•Make sure that the lamp cover is secured firmly.
Otherwise, the POWER indicator flashes red and green, disallowing the projector to be powered on.
B) When the projector is mounted to the ceiling
When removing the lamp unit from the projector mounted to the ceiling, never fail to use the lamp replacement attachment to protect yourself from glass fragments and so on.
•Contact your dealer when replacing the lamp unit with the projector mounted to the ceiling.
1.Remove the lamp cover referring to the procedure 1 and 2 of “A) When the projector is placed on the table”.
Caution:
•When opening the lamp cover to replace the lamp of the
2.Loosen the two screws (d) of the lamp unit.
(d) 
2. Remove the screw (b) and slide the lamp cover (c)
for removal.
(c)
(b)
Caution:
• When replacing the lamp, do not loosen the screws other than two screws (d). It may cause the failure of projector.