Onkyo TX-NR1008 instruction manual Precautions

Page 3

Precautions

1.Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal without the permission of the copyright holder.

2.AC Fuse—The AC fuse inside the unit is not user-ser- viceable. If you cannot turn on the unit, contact your Onkyo dealer.

3.Care—Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the unit immediately afterwards with a clean cloth. Don’t use abrasive cloths, thinners, alco- hol, or other chemical solvents, because they may damage the finish or remove the panel lettering.

4.Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the volt- age requirements printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable (easily accessible) at all times.

Pressing ON/STANDBY to select Standby mode does not fully shutdown the unit. If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet.

5.Preventing Hearing Loss Caution

Excessive sound pressure from earphones and head- phones can cause hearing loss.

6.Batteries and Heat Exposure Warning

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat as sunshine, fire or the like.

7.Never Touch this Unit with Wet Hands—Never han- dle this unit or its power cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer.

8.Handling Notes

If you need to transport this unit, use the original packaging to pack it how it was when you originally bought it.

Do not leave rubber or plastic items on this unit for a long time, because they may leave marks on the case.

This unit’s top and rear panels may get warm after prolonged use. This is normal.

If you do not use this unit for a long time, it may not work properly the next time you turn it on, so be sure to use it occasionally.

For U.S. models

FCC Information for User

CAUTION:

The user changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turn- ing the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit differ- ent from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV techni- cian for help.

For Canadian Models

NOTE: THIS CLASS B DIGITAL APPARATUS COM- PLIES WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle pour les Canadien

REMARQUE: CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB- 003 DU CANADA.

Sur les modèles dont la fiche est polarisée:

ATTENTION: POUR ÉVITER LES CHOCS ÉLEC- TRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPON- DANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

En

3

Image 3
Contents Advanced Operations Controlling iPod & Other Components Introduction ConnectionsAway from the rear panel or wall, creating a flue-like Always consider the environmental issues and follow10 cm 4 at the rear. The rear edge of the shelf or Board above the apparatus shall be set 10 cmPrecautions Aiming the Remote Controller Supplied AccessoriesUsing the Remote Controller Installing the BatteriesContents Processing Features40 FM/AM Presets excluding North American mod- els AmplifierAmplifier is prohibited THX Select2 PlusFront & Rear Panels Front PanelCBL/SAT , Game , PC , AUX , Tuner , TV/CD AUX Input jacks HDMI, VIDEO, Audio L/R and Digital 18 Return button Setup MIC jackDisplay Phones jack Zone 2, Zone 3 and OFF buttonsFront L/R, CENTER, Surr L/R UREMOTE Control jack Universal Port jack Ethernet portRear Panel Digital in Coaxial and Optical jacksControlling the AV Receiver Remote ControllerEnjoying Home Theater About Home TheaterSpeaker Connection Precautions Connecting the AV ReceiverConnecting Your Speakers Speaker ConfigurationScrew-type speaker terminals Strip 1/2 to 5/8 12 to 15 mm Connecting the Speaker CablesUsing Dipole Speakers Connecting Powered SubwoofersBi-amping the Front Speakers B c e Power amplifier I g Connecting a Power AmplifierHdmi cable About AV ConnectionsConnected image with AV components AV Cables and JacksConnecting Your Components with Hdmi Jack Signal Components AssignableAudio return channel ARC function Front Rear Connecting Your ComponentsStep Connecting Onkyo uComponentsHow to record the video Remote ControlAC Inlet Connecting AntennaConnecting the Power Cord North American European and Asian Taiwan models ModelsVideo Connection Formats Which Connections Should I Use?Audio Connection Formats Monitor Out setting set to AnalogPC in Analog RGB input signal is output at 720p resolution Depends on the Audio TV Out settingTurning Off Standby indicatorTurning On/Off the AV Receiver Turning OnPlaying the Connected Component Selecting the Language Used for the Onscreen Setup MenusSetting the Display Brightness Basic OperationsCh playback Using the Sleep TimerMuting the AV Receiver Selecting Speaker LayoutChanging the Input Display Using the Home MenuUsing Activities to Start Easy Macros Using HeadphonesEnter Audyssey MultEQ Room Correction and Speaker SetupUsing Audyssey MultEQ First measurement positionError Messages Using a Powered Subwoofer Changing the Speaker Settings ManuallyListening to the Radio Using the TunerTuning into Radio Stations Listening to the RadioUsing RDS excluding North American and Taiwan models Presetting FM/AM StationsFinding Stations by Type PTY Listening to Traffic News TPRDS program types PTY Connecting a Recording Component RecordingAV Recording Using the Listening Modes Listening Mode ButtonsSelecting Listening Modes Speaker Layout About Listening ModesExplanatory Notes Input SourceListening Modes Audio Resolution AudioDescription Input Speaker Source Layout DTS-HD High DTS-HD MasterListening Mode Description Input Speaker Source Layout Onkyo-Original DSP Listening Modes Menu Advanced SetupOn-screen Setup Menus Common Procedures in Setup MenuInput/Output Assign Monitor OutOUT Main Resolution Changing Monitor Out setting manuallyBD/DVD, VCR/DVR, CBL/SAT, GAME, PC TV/CD, PHONO, Port Here are the default assignmentsHdmi Input Component Video Input` in 1, Digital Audio InputAnalog Audio Input BD/DVD, VCR/DVR, CBL/SAT, GAME, PC, AUX TV/CD, PHONO, PortSpeaker Settings Speaker SetupLevel Calibration Speaker DistanceEqualizer Settings THX Audio SetupBGC Audio Adjust Multiplex/MonoDolby Theater-Dimensional Audyssey DSXLFE Level Dynamic EQ Source SetupDynamic Volume AudysseyIntelliVolume SyncName Edit Wide Mode*1*3 Picture AdjustGame Mode To correct a characterEdge Enhancement*2*4 Resolution*2*4Picture Mode*1 Film Mode*2*4*5Listening Mode Preset Miscellaneous Hardware SetupTuner Sirius Settings North American modelsAuto Power Down Firmware UpdateNetwork Speaker Levels Lock SetupUsing the Audio Settings Tone Control SettingsRe-EQ Audyssey SettingsLate Night Music OptimizerSetting the Incoming Digital Signal Fixed Mode Audio SelectorAudio Selector Connecting the AV Receiver About NETNetwork Requirements Listening to Other Internet Radio Click on the Preset Internet Radio tabListening to Internet Radio Listening to vTuner Internet RadioItems on the Internet Radio Top Menu Registering Presets*1Station and Song Presets Playing Music Files on a ServerWindows Media Player 11 Setup AAC Supported Audio File FormatsWMA WAVAbout Dlna Windows Media Player 12 SetupRemote Playback from Media Server/ Personal Computer Server RequirementsUsing Remote Playback Network SettingsDhcp About USB USB Mass Storage Device RequirementsPlaying Music Files on a USB Device Random Playback Multi Zone Connecting ZoneConnecting Your Zone 2 Speakers Directly to the AV receiver Connecting Your Zone 2 Speakers to an Amp in ZoneConnect your Zone 3 speakers to the AV receiver’s Front Connecting Your Zone 3 Speakers Directly to the AV receiverConnecting Your Zone 3 Speakers to an Amp in Zone Zone 3 12V TriggerSetting the Multi Zone Setting the Powered Zone 2/3TOR Using Zone 2/3Controlling Zone 2/3 with the Remote Controller Controlling Zone 2/3 from the AV receiverMuting Zones Adjusting the Volume for ZonesAdjusting the Tone and Balance of Zone Using a Multiroom Kit with Zone 2/3Using a Multiroom Kit with Other Components Using a Multiroom Kit with a CabinetControlling iPod Connecting the iPod Directly to the USB PortStandard Mode control Extended Mode controlConnecting an Onkyo Dock Models sold are different depending on the regionOnkyo Dock Cable UP-A1 Dock Using the Onkyo DockWith the RI Control Controlling Your iPodRI Dock Without the RI ControlE/rENTER PLAYLISTe/r Available buttonsOnkyo Dock Buttons UP-A1 Dock UDockPreprogrammed Remote Control Codes Looking up for Remote Control CodeControlling Other Components Select Skip, and then press Enter Use q/wto select Search by model numberVia network, and then press Enter Or if you are not sure about the exact modelRemote Mode BD/DVD Entering Remote Control CodesRemote Control Codes for Onkyo Components Connected via u Enter the appropriate remote control code forControlling Other Components Resetting Remote Mode ButtonsResetting the Remote Controller You can reset the remote controller to its default settingsCH + Disc + Components ButtonsCassettetape deck TV VOL q/wActivities Setup Learning Commands To learn more commands, repeat steps 2Message for transfer will appear Deleting Macros Using Normal MacrosDeleting Learning Commands Running MacrosCan’t turn on the AV receiver TroubleshootingStandby indicator flashes red There’s no sound, or it’s very quietOnly the center speaker produces sound There’s no sound with a certain signal formatCan’t select the Pure Audio listening mode About DTS signalsOn-screen menus don’t appear Remote controller doesn’t workThere’s no picture There’s no picture from a source connected to an HdmiStand-by power consumption Can’t learn commands from another remote controllerCan’t access the server or Internet radio Can’t access the music files on a USB deviceNent Video Monitor OUT How do I change the language of a multiplex sourceUfunctions don’t work CBL/SAT, GAME, or AUX inputVideo Section SpecificationsAmplifier Section Tuner Section GeneralOthers Audio OutputsAbout Hdmi Supported Audio FormatsAbout Copyright Protection Using an RIHD-compatible TV, Player, or Recorder About p-compatible componentsOperations that can be performed with p connection Operate with the remote controller How to connect and setupConfirm the connecting and setting Confirm the settingsVideo Resolution Chart OutputOutput 103 MemoOnkyo Europe Electronics GmbH UK Branch Onkyo Europe Electronics GmbH