Use q/wto select Search by model number

Tip

•If you cannot access the database, a message “Cannot connect to database.” will appear. Press ENTER to return to the previous step.

•If the brand name is not found, use rto select “Not Listed”, and then press ENTER.

The following screen appears.

8–1. Remote Mode Setup	TV
Category	TV
Brand	Sonic
Model	(Option)

		Skip
		Search by model number (via network)


8	Use q/wto select “Search by model number
	(via network)”, and then press ENTER.

The model number input panel appears.

	When you do NOT have a network connection
	or if you are not sure about the exact model,
	select “Skip”, and then press ENTER.
	If you select “Skip”, you will go to step 11.

9	Enter the model in a similar manner as in the
	case of the brand name (step 6).

Tip

•After entering the 3rd character, press ENTER to start searching.

•You cannot enter a space character.

10 Use q/wto select the model, and then press

ENTER.

If the model is not found, use rto select “Not Listed”, and then press ENTER.

After searching is completed, a message for remote control code transfer will appear.

8–1. Remote Mode Setup	TV
Category	TV
Brand	XXXXX
Model	xxxxx

Now we are ready to transfer data to the remote.

Please hold the remote so that it is facing the receiver.

Use ENTER button of your remote to activate “OK”.

Ready?

11 While pointing the remote controller at the AV receiver’s remote control sensor, press ENTER.

Remote control sensor (Transmitter)

Incoming sensor

	15
	15
	15° off center	Approx.
	15° off center	16ft. (5 m)
	(Left/Right/Up/Down)	16ft. (5 m)
	(Left/Right/Up/Down)

12 When you searched for the model, a message “Successful” will appear. Now the transfer is successful!

Go to step 15.

When you did NOT search for the model, the following screen appears.

Push any key (except for arrow buttons and ENTER) to see if the component responds.

8–1. Remote Mode Setup	TV
Category	TV
Brand	XXXXX
Code	xxxxx[*/*]

1. Push some key to see if the TV responds.

	(except Arrow and Enter.)
	2. Choose “Works” or “Doesn’t work”.
*1	*2

Works

Doesn’t work (Retry)

*1 When category other than TV have been selected, the content is different.

*2 Asterisks in [***/***] mean the order of the candi- date code and the total number of the codes for the brand.

13 If you can control component, press RECEIVER, use q/wto select “Works”, and then press ENTER.

8–1. Remote Mode Setup	TV
Category	TV
Brand	XXXXX
Code	xxxxx[*/*]

Now we are ready to transfer data to the remote.

Please hold the remote so that it is facing the receiver.

Use ENTER button of your remote to activate “OK”.

Ready?

If you cannot control component, press RECEIVER, use q/wto select “Doesn’t work (Retry)” and press ENTER.

The next code appears. Repeat from step 11.

14 Press ENTER to transfer the determined code.

Remote control sensor (Transmitter)

Incoming sensor

	15
	15
	15° off center	Approx.
	15° off center	16ft. (5 m)
	(Left/Right/Up/Down)	16ft. (5 m)
	(Left/Right/Up/Down)

15 Press ENTER.

You’ll return to the category selection menu. Press SETUP to end the remote mode setup.

Onkyo TX-NR1008 Use q/wto select Search by model number, Via network, and then press Enter

Tip