Onkyo TX-NR1008 Specifications, Amplifier Section Tuner Section, General, Video Section, Hdmi

Page 97

Specifications

Amplifier Section

 

Tuner Section

Rated Output Power All channels:

(North American)

135 watts minimum continuous power per channel, 8 ohm loads, 2 channels driven from 20 Hz to 20 kHz, with a maximum total harmonic distortion of 0.08% (FTC)

145 watts minimum continuous power per channel, 8 ohm loads, 2 channels driven at 1 kHz, with a maximum total harmonic distortion of 0.7% (FTC)

160 watts minimum continuous power per channel, 6 ohm loads, 2 channels driven at 1 kHz, with a maximum total harmonic distortion of 0.1% (FTC)

(Others)

9 ch ⋅ 180 W at 6 ohms, 1 kHz, 1 ch driven (IEC)

FM Tuning Frequency Range

(North American and Taiwan)

87.5 MHz - 107.9 MHz

(Others) 87.5 MHz - 108.0 MHz, RDS

AM Tuning Frequency Range

 

(North American and Taiwan)

 

530 kHz - 1710 kHz

 

(Others)

 

522/530 kHz - 1611/1710 kHz

Preset Channel

40

Digital Tuner (North American)

 

SIRIUS

General

 

 

 

Maximum Effective Output Power (Asian)

9 ch ⋅ 230 W at 6 ohms, 1 kHz, 1 ch driven

 

(JEITA)

 

Dynamic Power

300 W (3 Ω, Front)

 

250 W (4

Ω, Front)

 

150 W (8

Ω, Front)

THD (Total Harmonic Distortion)

 

0.08% (Power Rated)

Damping Factor

60 (Front, 1 kHz, 8 Ω)

Input Sensitivity and Impedance

200 mV/47 kΩ (LINE)

2.5 mV/47 kΩ (PHONO MM)

Rated RCA Output Level and Impedance

200 mV/470 Ω (PRE OUT)

Maximum RCA Output Level and Impedance 4.6 V/470 Ω (PRE OUT)

Phono Overload 70 mV (MM 1 kHz 0.5%)

Frequency Response 5 Hz - 100 kHz/+1 dB, -3 dB (Direct mode)

Tone Control Characteristics

 

±10 dB, 50 Hz (BASS)

 

±10 dB, 20 kHz (TREBLE)

Signal to Noise Ratio

110 dB (LINE, IHF-A)

 

80 dB (PHONO, IHF-A)

Speaker Impedance

4 or 6 Ω - 16 Ω

Power Supply

(North American and Taiwan)

 

AC 120 V, 60 Hz

 

(Others) AC 220 - 240 V, 50/60 Hz

Power Consumption

(North American and Taiwan) 8.8 A

 

(Others) 830 W

Stand-by Power Consumption

 

(North American and Taiwan) 0.2 W

 

(Others) 0.3 W

Dimensions

435 mm ⋅ 198.5 mm ⋅ 435.5 mm

(W ⋅ H ⋅ D)

17-1/8" ⋅ 7-13/16" ⋅ 17-1/8"

Weight

(North American and Taiwan)

 

18.6 kg (41.0 lbs.)

 

(Others) 18.7 kg (41.2 lbs.)

■ HDMI

 

Input

IN 1, IN 2, IN 3, IN 4, IN 5, IN 6,

 

AUX INPUT

Output

OUT MAIN, OUT SUB

Video Resolution

1080p

Audio Format

Dolby TrueHD, DTS Master Audio,

 

DVD-Audio, DSD

Supported

3D, Audio Return Channel, Deep Color,

 

x.v.Color, LipSync, CEC

■ Video Inputs

Video Section

 

 

Component

IN 1, IN 2

Input Sensitivity/Output Level and Impedance

S-Video

BD/DVD, VCR/DVR, CBL/SAT, GAME

Composite

BD/DVD, VCR/DVR, CBL/SAT, GAME,

1 Vp-p/75 Ω (Component and S-Video Y)

 

AUX

0.7 Vp-p/75 Ω (Component PB/CB, PR/CR)

 

Analog RGB input

PC IN

0.25 Vp-p/75 Ω

(S-Video C)

 

 

1 Vp-p/75 Ω (Composite)

■ Video Outputs

 

Component Video Frequency Response

 

 

5 Hz - 100 MHz/+0 dB, -3 dB

Component

MONITOR OUT

 

 

 

 

S-Video

MONITOR OUT, VCR/DVR OUT

 

 

Composite

MONITOR OUT, VCR/DVR OUT

 

 

■ Audio Inputs

 

 

 

Digital

Optical: 2 (Rear), 1 (Front)

 

 

 

Coaxial: 3

 

 

Analog

BD/DVD, VCR/DVR, CBL/SAT, GAME,

 

 

 

PC, TV/CD, AUX, PHONO

 

 

Multichannel Inputs

7.1

En

97

Page 96 Page 98
Image 97
Page 96 Page 98
Contents Advanced Operations Controlling iPod & Other Components Introduction Connections10 cm 4 at the rear. The rear edge of the shelf or Always consider the environmental issues and followBoard above the apparatus shall be set 10 cm Away from the rear panel or wall, creating a flue-likePrecautions Using the Remote Controller Supplied AccessoriesInstalling the Batteries Aiming the Remote ControllerContents 40 FM/AM Presets excluding North American mod- els FeaturesAmplifier ProcessingAmplifier is prohibited THX Select2 PlusFront Panel Front & Rear PanelsCBL/SAT , Game , PC , AUX , Tuner , TV/CD Display Return button Setup MIC jackPhones jack Zone 2, Zone 3 and OFF buttons AUX Input jacks HDMI, VIDEO, Audio L/R and Digital 18Rear Panel UREMOTE Control jack Universal Port jack Ethernet portDigital in Coaxial and Optical jacks Front L/R, CENTER, Surr L/RControlling the AV Receiver Remote ControllerEnjoying Home Theater About Home TheaterConnecting Your Speakers Connecting the AV ReceiverSpeaker Configuration Speaker Connection PrecautionsScrew-type speaker terminals Strip 1/2 to 5/8 12 to 15 mm Connecting the Speaker CablesConnecting Powered Subwoofers Using Dipole SpeakersBi-amping the Front Speakers B c e Power amplifier I g Connecting a Power AmplifierConnected image with AV components About AV ConnectionsAV Cables and Jacks Hdmi cableJack Signal Components Assignable Connecting Your Components with HdmiAudio return channel ARC function Front Rear Connecting Your ComponentsHow to record the video Connecting Onkyo uComponentsRemote Control StepConnecting the Power Cord Connecting AntennaNorth American European and Asian Taiwan models Models AC InletVideo Connection Formats Which Connections Should I Use?PC in Analog RGB input signal is output at 720p resolution Monitor Out setting set to AnalogDepends on the Audio TV Out setting Audio Connection FormatsTurning On/Off the AV Receiver Standby indicatorTurning On Turning OffSetting the Display Brightness Selecting the Language Used for the Onscreen Setup MenusBasic Operations Playing the Connected ComponentMuting the AV Receiver Using the Sleep TimerSelecting Speaker Layout Ch playbackChanging the Input Display Using the Home MenuUsing Activities to Start Easy Macros Using HeadphonesUsing Audyssey MultEQ Audyssey MultEQ Room Correction and Speaker SetupFirst measurement position EnterError Messages Using a Powered Subwoofer Changing the Speaker Settings ManuallyTuning into Radio Stations Using the TunerListening to the Radio Listening to the RadioUsing RDS excluding North American and Taiwan models Presetting FM/AM StationsListening to Traffic News TP Finding Stations by Type PTYRDS program types PTY Recording Connecting a Recording ComponentAV Recording Listening Mode Buttons Using the Listening ModesSelecting Listening Modes Explanatory Notes About Listening ModesInput Source Speaker LayoutListening Modes Description Input Speaker Source Layout DTS-HD High Resolution AudioDTS-HD Master AudioListening Mode Description Input Speaker Source Layout Onkyo-Original DSP Listening Modes On-screen Setup Menus Advanced SetupCommon Procedures in Setup Menu MenuMonitor Out Input/Output AssignOUT Main Resolution Changing Monitor Out setting manuallyHdmi Input Here are the default assignmentsComponent Video Input BD/DVD, VCR/DVR, CBL/SAT, GAME, PC TV/CD, PHONO, PortAnalog Audio Input Digital Audio InputBD/DVD, VCR/DVR, CBL/SAT, GAME, PC, AUX TV/CD, PHONO, Port ` in 1,Speaker Settings Speaker SetupLevel Calibration Speaker DistanceTHX Audio Setup Equalizer SettingsBGC Multiplex/Mono Audio AdjustDolby Audyssey DSX Theater-DimensionalLFE Level Dynamic Volume Source SetupAudyssey Dynamic EQSync IntelliVolumeName Edit Game Mode Picture AdjustTo correct a character Wide Mode*1*3Picture Mode*1 Resolution*2*4Film Mode*2*4*5 Edge Enhancement*2*4Listening Mode Preset Miscellaneous Hardware SetupTuner Sirius Settings North American modelsFirmware Update Auto Power DownNetwork Using the Audio Settings Lock SetupTone Control Settings Speaker LevelsLate Night Audyssey SettingsMusic Optimizer Re-EQAudio Selector Setting the Incoming Digital Signal Fixed ModeAudio Selector About NET Connecting the AV ReceiverNetwork Requirements Listening to Internet Radio Click on the Preset Internet Radio tabListening to vTuner Internet Radio Listening to Other Internet RadioStation and Song Presets Registering Presets*1Playing Music Files on a Server Items on the Internet Radio Top MenuWindows Media Player 11 Setup WMA Supported Audio File FormatsWAV AACRemote Playback from Media Server/ Personal Computer Windows Media Player 12 SetupServer Requirements About DlnaUsing Remote Playback Network SettingsDhcp USB Mass Storage Device Requirements About USBPlaying Music Files on a USB Device Random Playback Connecting Your Zone 2 Speakers Directly to the AV receiver Connecting ZoneConnecting Your Zone 2 Speakers to an Amp in Zone Multi ZoneConnecting Your Zone 3 Speakers to an Amp in Zone Connecting Your Zone 3 Speakers Directly to the AV receiverZone 3 12V Trigger Connect your Zone 3 speakers to the AV receiver’s FrontSetting the Multi Zone Setting the Powered Zone 2/3Controlling Zone 2/3 with the Remote Controller Using Zone 2/3Controlling Zone 2/3 from the AV receiver TORAdjusting the Tone and Balance of Zone Adjusting the Volume for ZonesUsing a Multiroom Kit with Zone 2/3 Muting ZonesUsing a Multiroom Kit with Other Components Using a Multiroom Kit with a CabinetStandard Mode control Connecting the iPod Directly to the USB PortExtended Mode control Controlling iPodModels sold are different depending on the region Connecting an Onkyo DockOnkyo Dock Cable UP-A1 Dock Using the Onkyo DockRI Dock Controlling Your iPodWithout the RI Control With the RI ControlOnkyo Dock Buttons UP-A1 Dock Available buttonsUDock E/rENTER PLAYLISTe/rLooking up for Remote Control Code Preprogrammed Remote Control CodesControlling Other Components Via network, and then press Enter Use q/wto select Search by model numberOr if you are not sure about the exact model Select Skip, and then press EnterRemote Control Codes for Onkyo Components Connected via u Entering Remote Control CodesEnter the appropriate remote control code for Remote Mode BD/DVDResetting the Remote Controller Resetting Remote Mode ButtonsYou can reset the remote controller to its default settings Controlling Other ComponentsCassettetape deck Components ButtonsTV VOL q/w CH + Disc +Activities Setup To learn more commands, repeat steps 2 Learning CommandsMessage for transfer will appear Deleting Learning Commands Using Normal MacrosRunning Macros Deleting MacrosStandby indicator flashes red TroubleshootingThere’s no sound, or it’s very quiet Can’t turn on the AV receiverCan’t select the Pure Audio listening mode There’s no sound with a certain signal formatAbout DTS signals Only the center speaker produces soundThere’s no picture Remote controller doesn’t workThere’s no picture from a source connected to an Hdmi On-screen menus don’t appearCan’t access the server or Internet radio Can’t learn commands from another remote controllerCan’t access the music files on a USB device Stand-by power consumptionUfunctions don’t work How do I change the language of a multiplex sourceCBL/SAT, GAME, or AUX input Nent Video Monitor OUTAmplifier Section Tuner Section SpecificationsGeneral Video SectionOthers Audio OutputsSupported Audio Formats About HdmiAbout Copyright Protection About p-compatible components Using an RIHD-compatible TV, Player, or RecorderOperations that can be performed with p connection Confirm the connecting and setting How to connect and setupConfirm the settings Operate with the remote controllerOutput Video Resolution ChartOutput 103 MemoOnkyo Europe Electronics GmbH UK Branch Onkyo Europe Electronics GmbH
Top Page Image Contents