Power Cable Connections and Switching the Power On/Off
Finishing
1
2
Switch off the power of the connected equipment
Switch off the power of the projector
Main unit operation: Press the STANDBY button.
Remote control operation: Press the STANDBY button.
STANDBY |
| MENU |
RGB |
| ENTER |
VIDEO | CANCEL | QUICK |
|
| Q |
FREEZE | MUTE | LAMP MODE AUTO |
1 2 3 4
ASPECT
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen will go off (in about 5 seconds) and the projector will enter the
Note
*The operation can be cancelled by pressing a button other than the STANDBY button.
*One more press of the STANDBY button will switch off the power.Power Off
OK ?
The STANDBY indicator changes to blink- ing amber and lights a steady amber after about 90 seconds (when the unit enters the standby mode).
|
| Lit green |
| Blinking amber |
|
|
| Lit amber | ||
|
|
| (Approximately 90 seconds) | Standby mode | ||||||
STATUS |
| STANDBY | STATUS |
|
| STANDBY | STATUS |
|
| STANDBY |
|
|
|
|
| ||||||
|
|
| ||||||||
3 Unplug the power cable
Check that the STANDBY indicator is lit in amber and then unplug the power cable.
The STANDBY indicator will go off when the power cable is unplugged.
WarrningDo not unplug the power cable while the STANDBY indicator is blinking amber. Doing so may shorten the life of the lamp or damage the projector.