Mitsubishi Electronics XD450U Projector is in the stand-by mode when the lamp is, Source

1 IMAGE
CONTRAST	Use to adjust the image contrast. The contrast becomes	opt.
			XGA60
	higher as the value increases.
BRIGHTNESS	Use to adjust the image brightness. The image becomes	IMAGE
		CONTRAST	0
	brighter as the value increases.
CineRichColor	Use to adjust the white level of the projected image. Select	BRIGHTNESS	0
	AUTO for normal use.	CineRichColor	AUTO
sRGB	Choose ON for projection emphasizing on the color	sRGB	OFF
	reproducibility.	COLOR MATRIX	COMPUTER
	• When sRGB is ON, CineRichColor, COLOR MATRIX,
		COLOR TEMP.	STANDARD
	COLOR TEMP., COLOR, TINT and GAMMA MODE can't
		COLOR	0
	be adjusted.
		TINT	0
COLOR MATRIX ...	Use to adjust the color balance in each color of the image.
		SHARPNESS	0
	See page 19.
		GAMMA MODE	AUTO
COLOR TEMP	Use to adjust the color temperature. See page 19.
COLOR	Use to adjust the color intensity of the image.
TINT	Use to adjust the color balance of the image. The color balance shifts to green as the value
	increases and shifts to purple as the value decreases. (Available only when VIDEO or S-VIDEO
	is chosen as the source.)

• When the TV50 (PAL, SECAM) signal is input, TINT can't be adjusted.

SHARPNESS........ Use to adjust the image sharpness. The image becomes sharp as the value increases. (Available

only when VIDEO or S-VIDEO is chosen as the source.)

GAMMA MODE .... When AUTO is selected, the appropriate gamma mode is automatically selected depending on

the input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select STANDARD for sport scenes and video sources. Select THEATER for film sources.

2 INSTALLATION

AUTO POWER ON ..... When ON is chosen, the lamp is automatically lit when the
			opt.	XGA60
power cord is plugged in the wall outlet. Choose ON when
using the projector mounted on the ceiling.	INSTALLATION
• The projector is in the stand-by mode when the lamp is			AUTO POWER	OFF
			ON
off. Use the remote control to turn on the lamp.			AUTO POWER	OFF
			OFF
AUTO POWER OFF .... Use to set the time elapsed before the projector enters			IMAGE	SETUP
			CAPTURE
the stand-by mode when there is no signal input from the			SPLASH	ON
		ON
source.			SCREEN
			BACK COLOR	BLUE
IMAGE CAPTURE Use to capture the screen for the splash screen. See page			MUTE MODE	BLACK
22.
			LAMP MODE	STANDARD
SPLASH SCREEN Choose ON to display the splash screen when the power is
			IMAGE	OFF
turned on.			REVERSE
• The splash screen can be changed. See page 22.

BACK COLOR ...... Use to select the background from among BLUE, BLACK and IMAGE, which will be displayed

when there is no signal input from the source. When IMAGE is selected, the splash screen will be displayed.

MUTE MODE........ Use to choose the background, either BLACK, or IMAGE, which will be displayed when the

MUTE button is pressed. When IMAGE is chosen, the splash screen will be displayed. LAMP MODE ........ Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness is kept

low and the projector operating noise is reduced, resulting in a longer lamp replacement interval. (For XD450U only)

•When the lamp mode is switched, the projected image may flicker. This is not a product mal- function.

•Do not change the setting of LAMP MODE frequently.

IMAGE REVERSE.... Use to reverse the projected image. Select MIRROR for rear projection with the tabletop-

mounted projector. Select MIRROR INVERT for front projection with the ceiling-mounted projector.

•You can't set IMAGE CAPTURE or SPLASH SCREEN when PASSWORD FUNCTION in the FEATURE menu has been set to SPLASH ID SCREEN to enable the password lock.

ENGLISH

EN - 17