Mitsubishi Electronics A101 user manual About this guide, How this guide is organised

Page 6

About this guide

This user guide contains the information you need to install and configure your A101 Wireless USB Adaptor.

How this guide is organised

This guide contains the following parts:

Chapter 1: Product introduction

This chapter describes the physical features of the A101 Wireless USB Adaptor. This section also presents the package contents, LED indicators, and recommended network settings.

Chapter 2: Hardware installation

This chapter provides information on how to install the A101 Wireless USB Adaptor.

Chapter 3: Configuration

This chapter provides information on the contents of the Driver CD.

Chapter 4: Troubleshooting

This chapter contains a troubleshooting guide for solving common problems you may encounter when using the A101 Wireless USB Adaptor.

Conventions used in this guide

To make sure that you perform certain tasks properly, take note of the following symbols used throughout this guide.

WARNING: Information to prevent injury to yourself when trying to complete a task.

CAUTION: Information to prevent damage to the components when trying to complete a task.

IMPORTANT: Information that you MUST follow to complete a task.

NOTE: Tips and additional information to aid in completing a task.

vi

Image 6
Contents A101 Wireless USB Adaptor User’s Manual Page Disclaimer Contents Troubleshooting About this guide How this guide is organisedConventions used in this guide Interface DimensionsStandard TechnologyChapter Package contents WelcomeTop view FeaturesDiamond Digital A101 Wireless USB Adaptor Bottom viewLED Indicators Rear viewNetwork setup Ad-hoc networkInfrastructure network Installation Installing the device drivers and utilities Click Install A101Installing the device Found New Hardware dialogueWall mounting Software Support Control Center Control Center iconsControl Center right-click menu Control Center left-click menuWireless Settings StatusStatus tab IP Config tab Connection tabPing tab Configuration Basic tabEncryption tab Two ways to assign WEP keysSite Survey About Wireless Settings Link StateTable of Icon Indications Command icons Other right-click optionsAbout Control Center Mobile Manager Main WindowFile menu Mobilise menuEdit menu Creating a new configuration View menuSoftware Support Diamond Digital A101 Wireless USB Adaptor Use this window to set the proxy server and printer sharing Network settings Wireless tab Editing a configurationGeneral settings Network TypeNetwork settings Identification tab TCP/IP settings Device tabTCP/IP settings-IP Address tab TCP/IP settings Wins tab TCP/IP settings Gateway tabTCP/IP settings DNS tab Internet settingsSharing settings Command buttonsSite Monitor main window Site MonitorLaunching Site Monitor To launch the Site MonitorMonitoring a connection Troubleshooting Troubleshooting ProblemInstructions contained in this User Guide ProblemAction Service Contacts Western Australia New Zealand