Controlling

How to display a projector address?

Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's address will be displayed in a 'Text box'. This text box disappears after a few seconds.

PROJECTOR

ADDRESS

001

To continue using your RCU, it is necessary to enter the same address with the digit buttons (address between 0 and 9). For exemple, if the Adrress Key displays projector address 003, then press the "3" digit button on the RCU to set the RCU's address to match the projector's address.

How to program an address into the RCU?

Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address with the digit buttons. That address can be any digit between 0 and 9.

When programming '0', zero address, the RCU will control a projector regardless of the projector's address. This feature allows multiple projectors with different addresses to be controlled by a single RCU.

Input selection

Port No

Projector input

Press Digit

 

 

 

 

Button

 

 

 

 

 

1

Comp. Video

1

 

2

S-Video1/Comp. Video*

2

 

3

RGB2

3

 

4/5

RGB2

4 or 5

 

4/5

Component video3

6

 

 

 

 

 

 

 

4/5

RGB with Tri level sync4

7

 

 

4/5

Component video

 

 

 

 

with Tri-level sync5

8

 

 

 

 

 

 

Only available when the optional Tri-level sync module is installed.

1Input signal Y/C (luma/chroma)

2Input signal : R, G and B with automatic sync detection between seperate sync (separate composite sync or with separate Hor

and Vert. sync) or sync on green (composite sync).

3Input signal : R-Y, Y and B-Y with separate composite sync or with separate Hor and Vert. sync or with composite sync on Y.

4Input signal : R, G and B with separate Tri level sync or with Tri- level sync on green.

5Input signal : R-Y, Y and B-Y with separate Tri level sync or with composite Tri-level sync.

*Video or S-Video : switchable in the Picture Tuning menu.

5975688 BARCOVISION 1609S 131097

With the digit buttons on the RCU, it is possible to select input sources, Video, S-Video, RGsB or RGBS, RG3sB or RGB3S.

When a valid and available source is selected, there will be informa- tion displayed on the screen about that source (if "Text" is on). This information includes :

-source number

-horizontal frequency

-vertical frequency

Source 2

Fh= 15.6 kHz

Fv= 60 Hz

When the entry is a non valid source

number, a warning appears on the screen : 'input not available'.

WARNING input not available

When a valid source number is selected, the projector will display this source or it will wait on the selected source number until the source

WARNING source not available

becomes available. A message 'source not available' will be dis- played for a short time.

4-3

Page 19
Image 19
Barco R9002249, R9002240 How to display a projector address?, How to program an address into the RCU?, Projector, Address