Barco R9002240, R9002249 owner manual Identification, Copy a block, Copy a Block

Service Mode

Identification

Highlight 'Identification' with the control disk and press ENTER.

The 'Identification' screen gives information concerning :

-projector address. To change the address of your projector, contact a qualified service technician.

-software version.

-configuration.

possible installations :

*front-ceiling

*front-table

*rear-ceiling

*rear-table

-baud rate PC : transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be the same as the baud rate of the connected computer. When there is a difference, contact a qualified service

technician to make the appropriate changes.

-Text ON/OFF

Indicates in operational mode if the bar scale and number indicator will be displayed and if warnings and failures will be displayed. ON : displayed

OFF : not displayed

The status can be changed by pressing the 'TEXT' key once on

theRCU.

-Serial no. : indicates the fabrication number of the projector. This number can be useful when calling for technical assistance.

SERVICE MODE

IDENTIFICATION

COPY A BLOCK

DELTE A BLOCK

DELETE ALL BLOCKS

CHANGE PASSWORD

CHANGE LANGUAGE

RUN TIME

SET TO MIDPOSITION

CONVERGENCE MID

DYNAMIC ASTIGMATISM

MORE...

VISION 1609s

Proj. address : 001

Soft. Version : 6.00

Config. : Ceiling

Front

Baudrate PC : 9600

Text : ON

Serial No. : 103589552

Copy a block

The copy a block function copies the settings of a selected block into the active block.

Highlight copy a block with the control disk and press ENTER. ENTER will select the highlighted item.

To copy the settings of a closed block to the block you are working on (active block), use the control disk to select a block.

All existing settings will be overwritten with the new settings.

Press ENTER to copy the selected block. A confirmation screen will be displayed.

If you are certain you wish to copy the contents of the selected block into the active block, press ENTER.

EXIT cancels the copy procedure and returns without copying the block.

SERVICE MODE

IDENTIFICATION

COPY A BLOCK

DELTE A BLOCK

DELETE ALL BLOCKS

CHANGE PASSWORD

CHANGE LANGUAGE

RUN TIME

SET TO MIDPOSITION

CONVERGENCE MID

DYNAMIC ASTIGMATISM

MORE...

			COPY MODE
Nr.	Src	Fh Fv			inp			conf
1	1	15.6 50			video			FC
2	3	31.2 60			RGB3S R T
3	-	15.6 50			intern			FC
4	2	31.5 50			RGB3S FC
5	-	33.7 60			intern			FC
6
7
8					Active block nr.
1
			Select	with			or
								COPY BLOCK
					All		settings
					in	current				block
					will		be	overwritten !
					<ENTER>					to confirm
					<EXIT>				to	cancel

7-2 5975688 BARCOVISION 1609s 131097