Messages, warnings and failures
8MESSAGES, WARNINGS AND FAILURES
INPUT 01
Fh= 15.6 kHz
Fv= 050 Hz
SOURCE 01
enter
password
x x x x
text on
text off
PROJECTOR
ADDRESS :
003
WARNING :
input not available
WARNING :
source not
available
WARNING :
invalid
key entry
When selecting a new source, information about this source will be displayed on the screen. Source number, horizontal and vertical fre- quencies of the displayed source.
Announcement of the selected source.
Message to enter your password. Password contains 4 digits.
These messages will be displayed on the screen when pushing the TEXT key.
Text ON : the 'bar scale indication' will be enabled during the change of an analog control in the 'opera- tional mode' + all warnings and failures will be displayed.
Text OFF : the 'bar scale indication' will be disabled during the change of an analog control in the 'opera- tional mode' + all warnings and failures will not be displayed.
Indication of the projector address when activating the 'ADDRESS' button on the RCU with a pencil or other small object.
When using the projector with the RCVDS, this warning will be dis- played when selecting an input slot of an RCVDS where the input board is missing.
The input is a valid input but the source is not connected to the input terminals or the input source is switched off.
When a wrong key is pressed on the RCU.
WARNING :
invalid
code entry
WARNING :
end of ad- just range
WARNING :
input no
longer available
WARNING :
input se- lector not available
WARNING :
invalid
frequency
input
table is deleted
FAILURE
I2C error
addr. : 7FH
FAILURE
short
circuit on
I2C bus
Message when the entered pass- word is wrong.
End of adjustment range.
Message will be displayed when the input source is no longer avail- able. The following message then appears: 'check input signal or select new source'.
It warns you to check the power connection or the power status of the RCVDS.
Next message will appear immediatly on the screen : 'go to
The entered frequency or applied frequency of the source is out of the projector's range.
Message to inform that selected table is deleted. This message will be followed by 'confirm message', on which the user has to answer.
Hardware failure. Call a qualified service technician for repair.
Hardware failure. Call a qualified service technician for repair.
5975688 BARCOVISION 1609s 131097 |
| |
|
