Location and Function of Controls

2LOCATION AND FUNCTION OF CONTROLS

REAR PANEL TERMINOLOGY

Communication Port (800 peripherals)

1* allows communication between the RCVDS switcher and the projector.

* allows connection of a remote IR receiver unit to the projector.

Port 3

2RGB Analog Input (9 pin female sub D connector). Allows a character generator, microcomputer, etc. having analog RGB outputs to be connected to the projector.

3

Port 4/5 : RGB-S Input (5x BNC connector):

RGB-S input : allows a character generator, microcom-

puter, video camera, etc. having analog RGB output to be connected to the projector.

Line inputs: - signals RED-GREEN-BLUE

-COMPOSITE sync. signal

-Tri level sync signal (option)

4connector): allows a video tape recorder, video camera, color receiver/monitor, etc. having video line output to be

connected to the projector.

75 ohm Termination Switch for Video signalsVIDEO Input (Composite video, 2x loop-through BNC

5

6

7

Projector Pilot Lamp : indicates the status of the projec- tor.

-unlit : mains (power) switch is not pressed.

-lit : mains (power) switch is pressed and the indicated color shows the projector mode:

Green color : operational mode of the projector.

Red color : standby mode of the projector.

Important : projector ("Operational" or "Standby") mode is defined during the installation of the projector. (Refer to a qualified technician for change).

S-VIDEO Input: S-Video or Video in, depending on the priority setting in the Picture Tuning menu.

For S-Video : Separated Y/C (luma-chroma) signal inputs and outputs for higher quality playback of Super VHS signals (4-pin S-VIDEO connector loop-through).

75ohm Termination Switch for S-Video signals For Video : Composite video inputs on pin 1 and 3.

Power Switch : press the switch to turn the projector ON.

Depending on the hardware set-up of the projector during installation, the projector switches to ‘Standby’ or to ‘Operational' mode. If in standby, the standby LED lights up.

V NOM 120/230 Volt

I MAX

7/5Amp

FREQ

50/60Hz

1 FRONT PANEL TERMINOLOGY

RS 232 Input Port

Connection between the projector and an IBM PC (or compatible) or MAC (RS422) for remote computer control and data communication.

2RS 232 Output Port

RS 232 Input Port allows a communication link for PC or MAC to the next projector in a series of projector.

5975628 BARCOGRAPHICS 1209S 010797

3

4

5

IR Sensor

receiver for control signals transmitted from the RCU.

IR Remote

Connector for remote input for hard wired remote control

AC Power input

2-1

Page 9
Image 9
Barco R9002249, R9002240 owner manual Location and Function of Controls, Rear Panel Terminology