Random Access Adjustment Mode

Blanking Adjustments

Blanking adjustments affect only the edges of the projected image and are used to frame the projected image on to the screen and to hide or black out unwanted information (or noise). A 0% on the bar scale indicates no blanking.

To start up the Blanking adjustments, follow the next procedure :

Push the control disk up or down to highlight BLANKING on the Geometry menu and then press ENTER.

The following blanking corrections are possible :

-top blanking

-bottom blanking

-left blanking

-right blanking

GEOMETRY

 

 

H PHASE

 

 

RASTER SHIFT

 

LEFT-RIGHT (E-W)

 

LEFT SIDE CORRECTION

 

TOP-BOTTOM (N-S)

 

H SIZE

 

 

V LINEARITY

 

 

V SIZE

 

 

BLANKING

 

 

Select with

or

 

then <ENTER>

 

<EXIT> to

BLANKING

 

 

TOP

 

 

BOTTOM

 

LEFT

 

RIGHT

 

Select with

or

 

then <ENTER>

 

<EXIT> to

return.

Top blanking

Therefore :

-if the internal # pattern was selected, this pattern remains on the screen.

-if the genlocked pattern was selected, the external source

will be displayed.

Left blanking

Right blanking

Adjust the next blanking alignments until the image is correctly framed or the unwanted information is blanked out.

To enter a blanking alignment, push the control disk up or down to highlight a function and press ENTER to activate this function.

Press EXIT to return.

BLANKING

TOP

BOTTOM

LEFT

RIGHT

Select with or then <ENTER> <EXIT> to return.

5975688 BARCOVISION 1609S 131097

Bottom blanking

Adjustment of the blanking on the of the image

Adjustment of the blanking on the bottom of the image

Correct by pushing the control disk up or down

Adjustment of the blanking on the left side

Adjustment of the blanking on the right side

Correct by pushing the control disk to the right or to the left

6-15

Page 37
Image 37
Barco R9002249, R9002240 owner manual Blanking Adjustments