Mitsubishi Electronics Installing the device drivers and utilities, Click Install A101

Page 14

2.1System requirements

Before installing the A101 Wireless USB Adaptor, make sure that your system meets the following requirements:

•Intel® Pentium® 4 or AMD K7/K8 system

•Minimum 64MB system memory

•Windows® 2000 (SP4)/XP (SP1) operating system

•Optical drive (for software installation)

•An available USB port (USB 2.0 recommended)

2.2 Installation procedures

Follow these instructions to install the A101 Wireless USB Adaptor in your computer.

1.Install the device drivers and utilities from the Driver CD.

2.Connect the device to your computer.

You must install the A101 drivers and utilities before connecting the device to your computer.

2.2.1 Installing the device drivers and utilities

To install the device driver and utilities on your computer:

1.Insert the Driver CD into the optical drive.

2.Click “Install A101

Wireless USB Adaptor Utilities/Driver” when the installation window appears.

3.Follow the prompts to install the A101 drivers

and utilities, then restart the computer once installation is complete.

If Autorun is NOT enabled on your computer, browse the contents of the Driver CD and double click the Setup.exe file to run the CD.

2-2	Chapter 2: Installation

Image 14

Contents A101 Wireless USB Adaptor User’s Manual Page Disclaimer Contents Troubleshooting Conventions used in this guide About this guideHow this guide is organised Interface DimensionsStandard TechnologyChapter Package contents WelcomeTop view FeaturesDiamond Digital A101 Wireless USB Adaptor Bottom viewLED Indicators Rear viewInfrastructure network Network setupAd-hoc network Installation Installing the device drivers and utilities Click Install A101Installing the device Found New Hardware dialogueWall mounting Software Support Control Center Control Center iconsControl Center right-click menu Control Center left-click menuStatus tab Wireless SettingsStatus IP Config tab Connection tabPing tab Configuration Basic tabEncryption tab Two ways to assign WEP keysSite Survey Table of Icon Indications About Wireless SettingsLink State Command icons Other right-click optionsAbout Control Center Mobile Manager Main WindowEdit menu File menuMobilise menu Creating a new configuration View menuSoftware Support Diamond Digital A101 Wireless USB Adaptor Use this window to set the proxy server and printer sharing Network settings Wireless tab Editing a configurationGeneral settings Network TypeTCP/IP settings-IP Address tab Network settings Identification tabTCP/IP settings Device tab TCP/IP settings Wins tab TCP/IP settings Gateway tabTCP/IP settings DNS tab Internet settingsSharing settings Command buttonsSite Monitor main window Site MonitorLaunching Site Monitor To launch the Site MonitorMonitoring a connection Troubleshooting Troubleshooting ProblemInstructions contained in this User Guide ProblemAction Service Contacts Western Australia New Zealand