Mitsubishi Electronics user manual Setting the LAN control LAN-Controlled Mode, EN-10

Page 10

Preparation/SetUp (continued)

Setting the LAN control (LAN-Controlled Mode)

1

Enter “3” and press the Enter key.

2

To enable the e-mail notification function of Projector- View, enter 1 and press the Enter key. (Default is OFF (0).) (See pages 12 - 15 for ProjectorView function.)

Setting the PJLink™ certification (PJLink certification Mode)

1

Enter “5” and press the Enter key.

•When you don’t use PJLink™ protocol communication, skip this item. (See page 16 for PJLink™.)

2

To enable the PJLink™ certification:

Enter “1” and press the Enter key. (Default is ON (1).)

EN-10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents
LAN Control Utility Contents Major functions Preparation/SetUpPreparation before using the network function System requirementsConnection InstallationPreparation/SetUp EN-3How to remove Mitsubishi Projector Control Device Installer EN-4Setting the IP address of the projector EN-5When using a Dhcp server EN-6When not using a Dhcp server EN-7Telnet setting EN-8Setting the display language of ProjectorView language Setting the password Password SetupEN-9 Setting the PJLink certification PJLink certification Mode Setting the LAN control LAN-Controlled ModeEN-10 Save and exit EN-11ProjectorView Using the ProjectorViewHow to start up EN-12ProjectorView main screen ProjectorViewEN-13 Mail notification function ProjectorView Virtual Remote controllerEN-14 ProjectorView Initial setting EN-15Support for the PJLink function EN-16Terms and definitions Support for the PJLink functionEN-17
Related manuals
Manual 17 pages 3.31 Kb