ProjectorView Initial setting, EN-15 | Mitsubishi Electronics

ProjectorView (continued)

Initial setting

To load information on the projector such as model name and lamp operating time, set the projector data in advance. Click the SETUP button on the ProjectorView main screen. The Projector Setup screen appears. Enter data according to the description of each setting item.

(Note 4)

You can’t change the Projector model, Serial number, Operating hours, and Lamp hours.

Each setting item is described as follows:

Projector name*	Name to identify the projector
Projector model	Model name of the projector

Projector location*	Location of the projector

Serial number	Serial number of the projector

SMTP IP address*	IP address of the SMTP server used for e-mail transmission (Example: 192.168.0.1)

E-mail address*	e-mail address to receive alert notiﬁcation e-mail (Example: administrator@XXX.XXX.XXX)

E-mail host*	User-deﬁned string displayed at the Internet header of e-mail message (Example: user)

E-mail from*	Sender of alert notiﬁcation e-mail (Example: PJView@XXX.XXX.XXX)
Operating hours	Cumulative projector operating time
Lamp hours	Cumulative lamp operating time calculated on the “Low” lamp mode basis.

Installation date*	Date when the projector was installed

Last lamp replacement date*	Date when the lamp was last replaced

Last maintenance date*	Date when the projector was last maintenanced

Virtual remote enabled	Display or hide the virtual remote controller (Check the box to display.)

* ) For data entry, use alphanumeric characters and symbols (+ - / = @ * _ ! ? . , ; : # $ % & ( ) < > [ ] { } " ').

(Note 5)

When the “Standard” lamp mode is selected, the indicated lamp operating time may exceed the indicated operating time. For example, when you use the projector in the “Standard” mode for 2 hours, the lamp operating time is indicated as 5 hours.