Mitsubishi Electronics user manual Support for the PJLink function, Terms and definitions, EN-17

Page 17

Support for the PJLink™ function (continued)

[Notes on Instant Shut Down]

Instant shutdown of the projector during control using the network function may cause ProjectorView to fail to display data correctly.

The operating time and temperature may not be displayed correctly. In this case, close the browser, recognize this projector using Mitsubishi Projector Control Device Installer, and then start the browser again. (Refer to “How to start up” of ProjectorView.)

When you use the e-mail notification function only, no special action is required.

[Terms and definitions]

For detailed descriptions, see commercial books.

Term

Definition

 

 

DHCP

Abbreviation for Dynamic Host Configuration Protocol. This protocol

 

automatically assigns IP addresses to networked devices.

 

 

Gateway

A server (or router) to communicate across networks (subnets) that are divided

 

by subnet mask.

 

 

IP address

Numerical address to identify networked computers.

 

 

MAC address

Abbreviation for Media Access Control address. MAC address is a unique ID

 

number assigned to each network adapter, based on which data are sent and

 

received between network adapters.

 

 

Subnet mask

A value to define the number of bits used for a network address of a divided

 

network (or subnet) in an IP address.

 

 

Telnet

A virtual terminal protocol to log in to and control a remote computer.

 

 

URL

Abbreviation for Uniform Resource Locator. URL is a unique Internet address of

 

each Web page.

 

 

EN-17

Image 17
Contents LAN Control Utility Contents Preparation before using the network function Preparation/SetUpMajor functions System requirementsPreparation/SetUp InstallationConnection EN-3EN-4 How to remove Mitsubishi Projector Control Device InstallerEN-5 Setting the IP address of the projectorEN-6 When using a Dhcp serverEN-7 When not using a Dhcp serverEN-8 Telnet settingEN-9 Setting the password Password SetupSetting the display language of ProjectorView language EN-10 Setting the LAN control LAN-Controlled ModeSetting the PJLink certification PJLink certification Mode EN-11 Save and exitHow to start up Using the ProjectorViewProjectorView EN-12EN-13 ProjectorViewProjectorView main screen EN-14 ProjectorView Virtual Remote controllerMail notification function EN-15 ProjectorView Initial settingEN-16 Support for the PJLink functionEN-17 Support for the PJLink functionTerms and definitions