Mitsubishi Electronics EN-1 user manual Connection, Installation, Preparation/SetUp, EN-3

Page 3

Preparation/SetUp (continued)

Connection

Computer

LAN cable (option)

(100BASE-TX or 10BASE-T should be supported.)

To LAN terminal

LAN cable (option) (100BASE-TX or 10BASE-T should be supported.)

External HUB

•Use a straight-through category-5 cable for LAN connection.

•Don’t touch the metal parts of the LAN connector and LAN cable because static electricity may be discharged from your body, causing damage to the projector.

Installation

Before starting installation, be sure to read “ReadMe.txt” contained in the CD-ROM.

	1	Copy three ﬁles (Installer_Mitsubishi.msi, Setup.Exe, and Setup.Ini) contained in the Tools folder of CD-
	1	ROM to the hard disk of your personal computer.
		ROM to the hard disk of your personal computer.

	2	Double-click the ﬁle named Setup.Exe.
	2

	3	When the following window appears, click Next.
	3

EN-3

Image 3

Contents LAN Control Utility Contents System requirements Preparation/SetUpPreparation before using the network function Major functionsEN-3 InstallationPreparation/SetUp ConnectionEN-4 How to remove Mitsubishi Projector Control Device InstallerEN-5 Setting the IP address of the projectorEN-6 When using a Dhcp serverEN-7 When not using a Dhcp serverEN-8 Telnet settingSetting the password Password Setup Setting the display language of ProjectorView languageEN-9 Setting the LAN control LAN-Controlled Mode Setting the PJLink certiﬁcation PJLink certiﬁcation ModeEN-10 EN-11 Save and exitEN-12 Using the ProjectorViewHow to start up ProjectorViewProjectorView ProjectorView main screenEN-13 ProjectorView Virtual Remote controller Mail notiﬁcation functionEN-14 EN-15 ProjectorView Initial settingEN-16 Support for the PJLink functionSupport for the PJLink function Terms and deﬁnitionsEN-17