Preparation/SetUp (continued)
Setting the IP address of the projector
Before setting the IP address, check that the projector has been LAN-networked and turn on the main power of the projector.
| 1 | Start the Projector-Control Device Installer. |
| • Select [Start] - [All Programs] - [Mitsubishi] - |
| |
| | [Mitsubishi Projector - Control Device Installer] (in |
| | the case of Windows® XP). |
| 2 | Click the Search button. |
| • | Mitsubishi projector is recognized. |
| |
(Note 1)
When Mitsubishi projector isn’t recognized, check the following.
•The firewall function has been disabled. (When it has been enabled, search may not be conducted.)
•The personal computer and the projector are on the same network. (For preventing unauthorized access.)
•More than one Projector-Control Device Installer isn’t running.
3 | Select a projector and click the Assign IP button. |
|
The Assign IP Address screen appears.
•For automatic IP address setting by the DHCP server, go to page 6. For IP address setting without using the DHCP server, go to page 7.
EN-5
LAN Control Utility Contents
Preparation before using the network function
Preparation/SetUp
Major functions
System requirements
Preparation/SetUp
Installation
Connection
EN-3
EN-4
How to remove Mitsubishi Projector Control Device Installer
EN-5
Setting the IP address of the projector
EN-6
When using a Dhcp server
EN-7
When not using a Dhcp server
EN-8
Telnet setting
EN-9
Setting the password Password Setup
Setting the display language of ProjectorView language
EN-10
Setting the LAN control LAN-Controlled Mode
Setting the PJLink certification PJLink certification Mode
EN-11
Save and exit
How to start up
Using the ProjectorView
ProjectorView
EN-12
EN-13
ProjectorView
ProjectorView main screen
EN-14
ProjectorView Virtual Remote controller
Mail notification function
EN-15
ProjectorView Initial setting
EN-16
Support for the PJLink function
EN-17
Support for the PJLink function
Terms and definitions
