PLUS Vision Data Projector user manual Preparing the Remote Control, Button Battery Replacement

Preparing the Remote Control

Button Battery Replacement

Using the remote control for the first time

The battery compartment is fitted with a transportation insulation sheet at the time of shipping. Pull out the sheet and remove it. The remote control is now ready for use.

Replacement Method

1 Insert the tip of a ballpoint pen or some other pointed object into the hole of the battery holder, then pull out to open.

2 Remove the old battery and in- stall a new button battery with (+) side facing upward in the battery holder.

3 Insert the battery holder into the re- mote control and push in until the battery holder closes with a "click" sound.

		H
			N
			A
n		CR20253V	P
			A
			J
M		OL	T S
	O2-LiCELL

CR2025

Purchase a CR2025 type battery for replacement.

		H
		N
		A
n		P
		CR20253V
		A
		J
M		S
		O
	O2-Li CELL
		CR2025

CAUTION

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type (CR2025) recommended by the manufacturer. Dispose of used batteries according to your local regulations.

Remote Control Range

Point the infrared transmitter of the remote control toward the remote control sensor located at the front or rear of the main unit and operate.

Reception of the remote control signal should generally be possible within the range illustrated below.

ACCESS Indicator

30˚

30˚

5m / 16.4 feet

20˚

Top View

Remote con- trol sensor

Remote con- trol sensor

Remote control in- frared transmitter

7m / 23 feet

20˚

	Remote control in-
Side View	frared transmitter

Function of the ACCESS Indicator

When the projector's remote control sensor receives the remote control signal, the ACCESS indicator flashes once and the projector begins operation. If the indicator does not flash, check the following points.

•The indicator will not flash when bright light strikes the projector's remote control sensor or the remote control's transmitter, or when there is an obstacle located in between that blocks the signal.

•The indicator will not flash when the button battery is exhausted.

	SELECT
ENTER	CANCEL

ACCESS

E-12