PLUS Vision Data Projector user manual Using the Presentation Timer

General Operation

Using the Presentation Timer

The presentation is given while checking the timer displayed on the screen.

The gauge display allows the remaining time to be known at a glance.

(1)Press the TIMER button to show the settings display. The display will close when an operation has not been made for about 10 seconds.

Presentation Timer Off

(1)

[Timer settings display]

Press the CANCEL button to close the display immediately.

(2) Press the "+" or the "–" button to set the time.			(2)
The setting contents are "off," and from 10 to 60 minutes (in
10-minute intervals)
Settings can also be made with the SELECT ￿￿ buttons.
	Presentation Timer	10 min.

(3)Press the ENTER button and start the timer.

•The display of the timer setting will close, the display of the timer will appear and simultaneously the timer will start.

Gauge (Blue)

[Timer Display]

	(3)
MENU	CANCEL

ENTER

TIMER	KSTN
ZOOM	VOL

The blue gauge indicates the remaining time. When the gauge disappears,the time is up.

The gauge continues to be displayed when the timer is stopped.

When the remaining time is "0" (Gray)

•Press the ENTER button to restart the timer. The timer will start with the same time setting.

•Press the CANCEL button to close the timer display. The timer setting will return to "off".

Moving the Position of the Timer Display

The SELECT ￿￿￿￿ buttons permit movement within the mov- able range of the timer display.

Movable Range of the Timer Display

Note:

*The timer display will be closed while the menu or the quick menu is displayed, and while a message is displayed; however, the timer will still be operating at such times. Also, the timer will not be displayed unless a signal is being input.

*While the presentation timer is being displayed, screen movement will not be possible in the zoom mode and the quick menu display will not operate with the projector buttons.

E-31