How to record a video source | Onkyo TX-NR1009 guide

No.		Jack/Port			Components	Assignable

H		MONITOR OUT			TV, projector, etc.
		BD/DVD IN			Blu-ray Disc/DVD player

		VCR/DVR IN			VCR or DVD recorder/digital video recorder, RI
					dock

		CBL/SAT IN			Satellite/cable set-top box, etc.

		GAME IN			Game console, RI dock

		PC IN			Personal computer

		TV/CD IN			TV, CD player, cassette tape deck, MD, CD-R,
					Turntable*2, RI dock
		PHONO IN			Turntable*2
I		Multichannel input*3			DVD player, DVD-Audio, Super Audio CD-
					capable player, MPEG decorder

J		COMPONENT	IN 1 (BD/DVD)		Blu-ray Disc/DVD player, RI dock	✔
		VIDEO		IN 2 (CBL/SAT)	Satellite/cable set-top box, RI dock, etc.	✔
				IN 2 (CBL/SAT)	Satellite/cable set-top box, RI dock, etc.	✔

				MONITOR OUT	TV, projector, etc.

K		PC IN*4			Personal computer

Note
*1	Do not connect the AV receiver’s USB port to a USB port on your computer. Music on your computer cannot be played through the
	AV receiver in this way.
*2	Connect a turntable (MM) that has a built-in phono preamp to TV/CD IN, or connect it to PHONO IN with the phono preamp turned
	off. If your turntable (MM) doesn’t have a phono preamp, connect it to PHONO IN. If your turntable has a moving coil (MC) type
	cartridge, you’ll need a commercially available MC head amp or MC transformer to connect to PHONO IN. See your turntable’s
	manual for details.
	If your turntable has a ground wire, connect it to the AV receiver’s GND screw. With some turntables, connecting the ground wire
	may produce an audible hum. If this happens, disconnect it.
*3	To select the multichannel input, select the BD/DVD input selector and see “Audio Selector” (➔ page 57). To adjust the
	subwoofer sensitivity for the multichannel input, see “Subwoofer Input Sensitivity” (➔ page 47).
*4	When you connect your personal computer to PC IN and select the PC input selector, the video of the personal computer is output
	from the HDMI outputs. However, if you have assigned the HDMI inputs to the PC input selector, the AV receiver will output

signals received from the HDMI inputs instead of signals from PC IN. To have the signals output from PC IN, select “- - - - -” for “PC” in the “HDMI Input” setting (➔ page 46).

•With connection D, you can enjoy Dolby Digital and DTS. (To record or listen the audio in Zone 2/3 as well, use D and H.)

•With connection H, you can listen to and record audio from external components while you are in Zone 2/3.

•With connection H, if your Blu-ray Disc/DVD player has both the main stereo and multichannel outputs, be sure to connect to the main stereo.

■How to record a video source

With the connections described above, you cannot record the videos through the AV receiver. See “Recording” about connections for video recording (➔ page 43).