Onkyo TX-NR1009 Advanced Setup, On-screenSetup Menus, Common Procedures in Setup Menu, page

Advanced Setup

The on-screen menus appear only on a TV that is connected to the HDMI OUT MAIN. If your TV is connected to other video outputs, use the AV receiver’s display when changing settings.

This section describes the procedure for using the remote controller unless otherwise specified.

On-screen Setup Menus

MENU

a1. Input/Output Assign b 2. Speaker Setup

c 3. Audio Adjust d 4. Source Setup

e 5. Listening Mode Preset f 6. Miscellaneous

g 7. Hardware Setup

h 8. Remote Controller Setup i 9. Lock Setup

a Input/Output Assign			f Miscellaneous
	(➔ page 45)		(➔ page 59)
				6. Miscellaneous
		1. Input/Output Assign
1.		Monitor Out	1.	Volume Setup
2.		HDMI Input	2.	OSD Setup

3.Component Video Input

4.Digital Audio Input

5.Analog Audio Input

b Speaker Setup			g Hardware Setup
	(➔ page 47)		(➔ page 59)
		2. Speaker Setup		7. Hardware Setup
1.		Speaker Settings	1.	Remote ID
2.		Speaker Configuration	2.	Multi Zone
3.		Speaker Distance	3.	Tuner
4.		Level Calibration	4.	HDMI
5.		Equalizer Settings	5.	Auto Standby
6.		THX Audio Setup	6.	Network
			7.	Firmware Update
c Audio Adjust			h Remote Controller
	(➔ page 51)		Setup (➔ page 73)
		3. Audio Adjust		8. Remote Controller Setup
1.		Multiplex/Mono	1.	Remote Mode Setup
2.		Dolby	2.	Activities Setup

3.DTS

4.Audyssey DSX

5.Theater-Dimensional

6.LFE Level

d Source Setup		i Lock Setup
	(➔ page 53)	(➔ page 63)
	4. Source Setup		9. Lock Setup
	1. Audyssey	Setup

2.IntelliVolume

3.A/V Sync

4.Name Edit

5.Picture Adjust

6.Audio Selector

eListening Mode Preset (➔ page 58)

5.Listening Mode Preset

1.BD/DVD

2.VCR/DVR

3.CBL/SAT

4.GAME

5.PC

6.AUX

En

44

Common Procedures in Setup Menu

RECEIVER

ENTER

q/w/e/r

SETUP RETURN

The on-screen setup menus appear on the connected TV and provide a convenient way to change the AV receiver’s various settings. Settings are organized into 9 categories on the main menu.

Carry out the settings by using the on-screen display.

1 Press RECEIVER followed by SETUP. Tip

•If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2	Use q/wto select a menu, and then press ENTER.
3	Use q/wto select a target, and then press ENTER.
4	Use q/wto select an option, and use e/rto change
	the setting.

Press SETUP to close the menu.

Press RETURN to return to the previous menu.

Note

•This procedure can also be performed on the AV receiver by using SETUP, the arrow buttons, and ENTER.

•During Audyssey MultEQ® XT Room Correction and Speaker Setup, messages, etc., that are displayed on the TV screen will appear in the Display.

Explanatory Notes

a Main Menu Speaker Configuration

b■ Subwoofer

c`Yes `No

aMenu selection

bSetting target

cSetting options (default setting underlined)