Listening to FM/AM radio
You can listen to FM and AM broadcasts through the
Automatic tuning
1.Rotate INPUT SELECT to select tuner (FM or AM).
Or select TUNER with the remote control to select tuner (FM or AM).
Tip
Refer to the “Selecting the input source” on the page 25 to select the tuner mode.
2.Press TUN. - or TUN. + for more than 2 seconds.
Press TUN. - for more than 2 seconds to scan from high to low.
Press TUN. + for more than 2 seconds to scan from low to high.
The unit stops scanning whenever a station is received.
Note
In case of FM stereo reception, if the FM stereo reception is poor and “ST.” flashes in the display window, select monaural audio so that the sound will be less distorted by pressing the MO./ST.
-The “ST.” indicator disappears in the display window.
There will be no stereo effect, but the reception will improve. Press the button again to restore the stereo effect.
Manual tuning
Press TUN. - or TUN. + briefly and repeatedly on the FM or AM mode to select a station you want.
Presetting radio stations
You can preset up to 50 FM or AM stations.
Then you can easily tune in the stations you often listen to.
1.Rotate INPUT SELECT to select tuner (FM or AM).
Or select TUNER with the remote control to select tuner (FM or AM).
Tip
Refer to the “Selecting the input source” on the page 25 to select the tuner mode.
2.Tune in the station that you want to preset using Automatic tuning or Manual tuning.
3.Press PROG./CLEAR.
A preset number flashes in the display window for a few seconds. When a preset number flashes, do step the 4.
4.Press PRESET - or PRESET+ to select a preset number you want.
If a preset number is not flashed before you select the preset number, start again from the step 3.
5.Press PROG./CLEAR again.
The station is stored to the selected preset number.
If a preset number is not flashed before you press PROG./CLEAR, start again from the step 3.
6.Repeat the steps 2 to 5 to preset another station.
To clear all the stored stations
1.Press and hold PROG./CLEAR for about two seconds.
“ERASE ALL” appears in the display window.
2.Press PROG./CLEAR again.
All the presetting stations are cleared.
Notes
•If you have accidentally entered into the "ERASE ALL" mode and you do not wish to clear the memory, do not press any key. After a few seconds, "ERASE ALL" will go out by itself and change to normal mode.
•If all stations have already been entered, “FULL” will appear in the display window for a moment and then a preset number will flash. To change the preset number, follow the steps
28