Onkyo TX-SR700/700E, TX-SR600/600E Connecting antennas, Assembling the AM loop antenna

Page 34

Connecting antennas

To use the tuner of the TX-SR700/700E/600/600E, it is necessary to prepare the supplied FM and AM antennas.

•Adjustment and placement of the FM and AM antennas for better reception must be done while listening to a station broadcast.

•If better reception cannot be obtained, then placement of an outside antenna is recommended.

Assembling the AM loop antenna

Assemble the loop antenna as shown in the illustration.

•Refer to “Connecting the AM loop antenna” below for details on how to connect the loop antenna.

Insert into the hole.

Connecting the included antennas

Connecting the FM indoor antenna:

The FM indoor antenna is for indoor use only. During use, extend the antenna and adjust its orientation until the clearest signal is received. Fix it with push pins or similar items in the position that will cause the least amount of distortion.

If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.

Connecting the AM loop antenna:

The AM loop antenna is for indoor use only. Set it in the direction and position where you receive the clearest sound. Put it as far away as possible from the TX-SR700/700E/600/600E, televisions, speaker cables, and power cords.

If the reception is not very clear with the attached AM indoor antenna, the use of an outdoor antenna is recommended.

FM antenna

(Indoor)

AM loop antenna

Other models

Connecting the AM antenna cable

1.Press down the lever at the antenna terminal.

2.Insert the wire into the terminal hole.

3.Release the lever.

1

2

3

 

 

 

 

 

ANTENNA

USA and

 

 

 

 

 

 

Canadian

 

 

 

 

R

L

models

FM

AM

 

 

PHONO IN

75

 

 

 

 

 

DIGITAL INPUT

DIGITAL

VIDEO 3

VIDEO 2

 

 

 

OUTPUT COAXIAL

IN

OUT

IN

OU

2

OPTICAL

OPTICAL

 

 

 

 

1

 

 

 

 

 

 

 

COAXIAL

 

 

 

 

 

 

DIGITAL

 

 

 

 

 

 

INPUT

 

 

 

 

 

IN

OUT IN

IN

OUT

IN

OU

Strip away the insulation from the end of the cable, and fully insert the stripped end of the cable.

Hint:

Either of the split ends of the AM antenna can be connected to either terminal. Unlike speaker cabling, there is no polarity for AM broadcast signals.

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents TX-SR700/700E TX-SR600/600E Important Safeguards AvisPrecautions Contents Contents Features TX-SR700/700E Amplifier FeaturesSetting the voltage selector Worldwide models only Supplied accessoriesBefore using this unit Using the remote controllerFront panel facilities TX-SR700E TX-SR600ETuning Front panel facilitiesPhones jack Pure Audio button and indicator TX-SR700/700E only 49Audio Selector button Speakers A/B buttons TX-SR600/600E onlyTuning indicators Muting indicatorListening mode or digital input format indicators Sleep indicatorRemote controller Remote controller Connections Connections Signal flow Connecting your audio componentsConnecting a compact disc player CD Connections TX-SR700/700EConnecting a DVD Player with 5.1-Channel Output Connecting your video componentsFlow of the video signals is as follows Connecting a DVD Player with 2-Channel L/R Audio Output Connecting a DVD player DVDConnecting a video cassette recorder Video Connecting a television monitor or projector Monitor OUT Monitor OUT12V Trigger Zone 2 terminal Connecting video camera, etc. Video 4 InputPower amplifier Front right speakerFrom connecting block When using the Zone 2 Speakers terminals Connecting the remote zone Zone 2 speakersWhen using the Zone 2 PRE OUT terminals TX-SR700/700E onlyConnections TX-SR600/600E Video 3 Video White Analog audio output Red Digital audio output coaxial Satellite tuner or television Video 2/3 OUT Front panelConnections TX-SR700/700E/600/600E Power on/ready functionPower off function Direct change functionMinimum speaker configuration for surround sound playback Connecting speakersStandard speaker setup for surround sound Speaker placementConnecting a subwoofer Connecting speakersConnecting speakers Connecting the speaker cableSubwoofer Surround Front Center Right Speaker LeftRight Back Left Speaker Turning on the power Connecting the powerTurning on the power from the remote controller Connecting the AM antenna cable Connecting antennasConnecting the included antennas Assembling the AM loop antennaConnecting an AM outdoor antenna Connecting antennasConnecting an FM outdoor antenna Directional linkageReturn Setup Enter Configuring the speakersSpeaker Configuration Displaying the Main MenuConfiguring the speakers Adjustable Crossover 80/100/120 Hz for Bass ManagementMain menu and then press the Enter button Calibrating the speaker levelsUse the and cursor buttons to select Left Buttons used for navigating through the menus Using the remote controller Press the Test buttonPress the Test button to complete the procedure Displaying the Main Menu and exiting the menuFM Mode Tuner Tuning Listening to a stereo radio station FM modeTuning into a radio station Listening to Radio BroadcastsErasing a preset radio station Presetting a radio stationSelecting a preset radio station Listening to Radio BroadcastsListening to RDS broadcasts What is RDS?Listening to RDS broadcasts European models only PTY program types in EuropePerforming a PTY scan Listening to RDS broadcastsDisplaying Radio Text RT Performing a TP scanBasic operation TX-SR700/700E Master VolumeSelecting an Audio Component ModeBasic operation TX-SR600/600E Speakers A/B Rcvr ModeSelecting an Audio Component Selecting speakers Speakers A, B TX-SR600/ 600E onlyTo change the display of the input source from Tape to MD Selecting the type of audio input signalTemporarily changing the speaker output levels CH SEL Audio SEL Level TAP Tape Audio SelectorEnjoying DVD multichannel audio playback Using the sleep time remote controller onlyListening with headphones TX-SR700/700E onlySwitching the display Temporarily turning off the soundListening Modes Listening Modes Cine Fltr Selecting a listening modeTip While playing back Dolby Digital 2-channel sourcesPress the Cine Fltr button on the remote controller Original filter CinemaFILTER loading for moviesMenu Return Input SetupSetup Digital InputDigital Format Input SetupIntelliVolume MultichannelPCM fs96kHz Source Relationship between input source and listening modeAnalog/PCM Source Digital Format SourceTo display the OSD Setup menu OSD Setup and Other SettingsOSD Setup PreferenceSetting Values Initial value Audio AdjustSetup Procedure Press the Audio Adjust button Bass, TrebleAudio Adjust Settings possible for each listening mode NightEnjoying music in the remote zone TX-SR700/700E only Using the buttons on the TX-SR700/700EAdjusting the volume for the remote zone Zone Level Standby Sleep OFFREC OUT Recording a source TX-SR700/700EStart recording at the recording component as desired Recording a source TX-SR600/600E Rcvr Mode VOL Using remote controllerCalling up a preset radio station Rcvr Mode VOL MutingPress the CD Mode button Using remote controllerOn Standby CD Mode Disc Controlling an Onkyo CD playerSearch Press the DVD Mode buttonControlling an Onkyo DVD player DVD operation buttons Numeric keysTV Mode TV VCR Mode VCR VOL Muting VCR and TV Mode buttonsOn Standby MD Mode Controlling an Onkyo MD recorderLearning a pre-programming code When entering the code of Onkyo DVD playersEntering a pre-programming code DisplayDVD Entering a pre-programming codePre-programming codes VCRVCR Mode VCR Mode Operating your programmed remote controllerDVD Mode DVD Player Mode TV Mode TV ModeLight Programming procedureMacro 1 Macro Page Press and release the same Mode button again Erasing the programmed command from one buttonErasing all the commands programmed under a Mode button Press and release the same button againProgramming the macro Using the macro functionMacro 1 Rcvr Mode CD Mode Executing the macroErasing a macro from the Macro 1 or 2 button Using the macro functionErasing all commands and macros that have been programmed Press the Macro 1 or 2 button againMacro mode programming memo Troubleshooting guide Troubleshooting guide Video and AudioIf one of the messages shown below appears Specifications TX-SR700/700E Amplifier Section Tuner SectionSpecifications TX-SR600/600E Onkyo Europe Electronics GmbH

TX-SR600/600E, TX-SR700/700E specifications

The Onkyo TX-SR700/700E and TX-SR600/600E are renowned audio/video receivers that have significantly enriched the home theater experience since their release. These models exemplify Onkyo’s dedication to high-fidelity sound and advanced technology, making them a favorite among audiophiles and home theater enthusiasts alike.

A standout feature of the TX-SR700/700E is its exceptional audio performance. It boasts a powerful amplification system, providing 100 watts per channel, ensuring immersive sound that fills the room. Additionally, the receiver supports a variety of surround sound formats, including Dolby Digital, DTS, and Dolby Pro Logic II, allowing users to enjoy their favorite movies, music, and games with impressive clarity and depth.

The TX-SR600/600E, while slightly more compact, still delivers remarkable audio performance. With comparable power, this model maintains high-quality sound output and supports a range of listening modes. Both receivers feature Onkyo's proprietary Wide Range Amplification Technology (WRAT), which enhances dynamic sound reproduction while minimizing distortion, ensuring that even the most delicate audio details are preserved.

Connectivity is another strong point for these models. The TX-SR700/700E and TX-SR600/600E come equipped with a variety of HDMI inputs, allowing seamless integration with modern devices. This feature supports high-definition video and audio transmission, making it easy to connect Blu-ray players, gaming consoles, and streaming devices. Furthermore, the receivers are compatible with older technologies, providing versatility for various home entertainment setups.

One notable characteristic of both models is their robust video processing capabilities. They support up to 1080p video resolution and include advanced scaling features, ensuring that standard-definition content looks stunningly sharp on high-definition displays. Additionally, the user-friendly interface and remote control simplify operation, making it easy for users to navigate settings and adjust audio/video parameters quickly.

The TX-SR700/700E and TX-SR600/600E also incorporate advanced digital technologies such as Audyssey MultEQ, which automatically calibrates the audio settings based on room acoustics, providing an optimized listening experience. This feature is crucial in achieving balanced sound in any room environment.

In conclusion, the Onkyo TX-SR700/700E and TX-SR600/600E are exemplary models that combine power, flexibility, and advanced technology. With their rich sound quality, extensive connectivity options, and user-friendly features, these receivers remain a worthwhile investment for anyone looking to enhance their home theater system. Whether for movie nights, gaming, or casual listening, these Onkyo receivers are poised to deliver an unforgettable audio experience.
Top Page Image Contents