Planar PE1900 manual

Page 8

4.Plug the analog video signal cable into the Analog Video Input port on the back of the display (as shown above).

5.Connect the other end of the video cable into your computer’s video port. (Please check your computer’s documentation if you’re not sure where the port is located.)

Note: For best display performance, it is strongly recommended that you use Auto Setup to automatically configure your display’s settings.

Image 8

Contents PE1900 Page Contents Introduction FeaturesFor Your Safety Page Locations and Functions of Controls InstallationUnpacking the Display Making the Connections Button Function DescriptionPage Using Your Display Turning the Display On and OffTilting the Display Setting the Video ModeSetting the Refresh Rate Minimizing Power Consumption Caring for and Cleaning the DisplayPlug in the display Turn on your PC and display Displaying the OSD Main Menu Adjusting Your DisplaySummary of Control Buttons Selecting Items in the OSD Menu Adjusting the OSD MenuAuto Setup Adjusting the Management Submenu Page Page Adjusting the Clock/Phase Submenu Adjusting the Color Submenu Page Adjusting the OSD Display submenu Adjusting the Factory Recall Selecting your preferred Language Exit and Clear the OSD MenuUsing the Direct Keys BrightnessPage Troubleshooting Message Signal Out Of Range appears on my displayMessage Check Cable appears on my display Message No Sync appears on my displayImage is very unstable Technical Information Display InformationVideo Modes Unknown Video ModesRegulatory Information FCC Statement FCC Notice PartPage Planar SYSTEMS, INC