Oregon Scientific EB833 Altitude Alarm, Altitude Sampling Rate, Normal Altimeter Display

Page 8

EN

5.Press [+] or [-], the memory resets to the current actual altitude.

6.Press [ALT], and proceed to the accumulative vertical ascent / decent memory. The subsequent accumulative vertical ascent / decent digits flash.

7.Press [+] or [-], the vertical ascent / decent memory resets to 0 m. / ft.

8.Press [ALT] a last time and the unit returns to the Altitude Max (or Min) Memory Display.

NOTE The EB833 will return to Altitude Max/Min Memory Display if no buttons are pressed for 1 minute.

THE ALTITUDE ALARM

The Altitude Alarm can be set to activate when a specific altitude is reached.

To set the altitude alarm:

1Enter Altitude Alarm Display.

2.Press and hold [ALT] for above 2 seconds. The indicator will display.

3.Press the [+] and [-] to increase / decrease the altitude reading. Press and hold for 100-meter acceleration increments.

4.Press [ALT]

5.Press [+] or [-] to deactivate the alarm (the indicator disappears) or [+] or [-] to activate the alarm ( indicator appears).

6.Press [ALT], the ALTALARM indicator stops flashing.

The indicator will appear and the alarm will

activate at the specified elevation.

7.Press [ALT] again and the Altimeter exits the setting sequence. If the alarm is set to activate at a specified altitude, the will be displayed.

NOTE The unit will return to the Altimeter Display if no buttons are pressed for 2 minutes.

The altitude alarm setting ranges is between –500m and 7000m.

ALTITUDE SAMPLING RATE

The EB833 automatically samples altitude level at a rate of 2 seconds or 15 minutes.

When detecting a significant change in altitude, the unit will automatically increase the Altitude Sampling Rate to 2-second intervals.

When maintained at the same elevation for 10 minutes or longer, the device will automatically decrease the rate at which altitude samples are taken.

To manually force a change in the frequency at which altitude samples are taken:

1.In Normal Altimeter Display.

2.Press and hold (+) for about 2 seconds. The Altitude Sampling Rate will increase to 2-second intervals.

3.Press and hold (-) for about 2 seconds. The Altitude Sampling Rate will decrease to 15-minute intervals.

8

EB833(EN3)

8

8/31/04, 3:40 PM

Image 8
Contents Table of Contents Introduction Description of PartsInstalling and Replacing of Battery Follow these steps to install or replace batteries To view display sequences in Altimeter ModeGeneral Operation of the Altimeter Normal Altitude DisplayPress ALT again, Altitude History Display Display show Display Display showsDisplay About the Altitude Change Graph Altitude CalibrationUnits of Measurement for Altitude To clear Altitude Mode Memories Altitude History DisplayAbout Altitude Change Memory To numerically display previous altitude levelsNormal Altimeter Display Altitude AlarmAltitude Sampling Rate Barometer and Weather Forecast Functions To ensure that accurate altitude readings are maintainedBarometric Calibrations Units of Measure for Barometric PressureAbout the Pressure Change Graph Pressure History DisplayTonumericallydisplaypreviousbarometricpressure levels To ensure that accurate barometric readings are maintainedTo View Different Time and Date Mode displays Press Time again to view the Timer Display Display showsGeneral Operation of the Time and Date Functions Normal Time DisplayDaily Alarm To Set the Alarm TimeTime and Date Current time and date can be set sequentiallyDeactivating the Alarm COUNT-UP TimerTemperature Display Resetting the UnitMaintenance Specifications Altimeter FunctionsBarometer Functions Thermometer FunctionsTime resolution Second Timer FunctionsCalendar Clock Functions Hours formatAbout Oregon Scientific Call 949-608-2848 in the USOregon Scientific. All rights reserved EB833EN3 31/04, 340 PM