Mitsumi electronic WD3300U Advanced features, Password function, To enable the password function

Advanced features (continued)

Password function

This projector is equipped with the password function that is designed for prevention of wrong operation by children and restriction on operation by other than specified users. The password function has 3 modes as follows.

DISPLAY INPUT........... When the projector is turned

on, the startup screen (or splash screen) will appear and stay on the screen until the password is entered. When the password is entered, the startup screen will switch to the regular operation screen.

MENU ACCESS........... All the buttons except for the

POWER button on the projector are disabled. (The buttons on the remote control are enabled.) You can use this mode as a measure of prevention

of wrong operation by children and restriction on operation by other than specified users.

SPLASH ID SCREEN... IMAGE CAPTURE and SPLASH SCREEN in the INSTALLATION menu become unavailable. SPLASH SCREEN will be set to ON automatically.

To enable the password function:

1.Display the FEATURE menu.

2.Press the  or  button to select PASSWORD FUNCTION.

3.Press the  or  button to change the mode

among DISPLAY INPUT, MENU ACCESS and

SPLASH ID SCREEN.

•When the password has already been set, the mode won’t be changed. In such cases, press the ENTER button to cancel the password function and try again.

4.Press the ENTER button.

•The screen for setting the password function will appear.

opt.

FEATURE

MENU ACCESS

LOCK	OK
UNLOCK	OK

5.Press the ENTER button.

• The screen for entering a password will appear.

8.Enter the password again for confirmation using the same steps.

9.Press the ENTER button.

•If the entered passwords don’t match, an error message will appear.

•To cancel the procedure, press the MENU button.

To cancel the password function:

1.	Display the FEATURE menu.
2.	Press the  or  button to select PASSWORD
	FUNCTION.
3.	Press the ENTER button.
	• The screen for canceling the password function
	will appear.
	opt.
	FEATURE
	MENU ACCESS
	LOCK	OK
	UNLOCK	OK
4.	Press the ENTER button.
	• The screen for entering the password will
	appear.

PASSWORD

1

4 2 O K : ENTER CANCEL : MENU

3

5.Enter a 4 - 8 digit password using the , ,  and  buttons on the remote control as shown below.

(=1, =2, =3, =4)

6.Press the ENTER button.

•If you enter a wrong password, an error message will appear.

•To cancel the procedure, press the MENU button.

Important:

•Disable the password by pressing the MENU and ENTER buttons on the projector at the same time.

PASSWORD

CONFIRM

1

4 2

3

O K : ENTER CANCEL : MENU

6.Enter a 4 - 8 digit password using the , ,  and  buttons on the remote control as shown below.

(=1, =2, =3, =4)

7.Press the ENTER button.

•To cancel the procedure, press the MENU button.

EN-38