Settings menu
Audio: allows adjustments to the Balance and Volume. Also allows you to turn on and off the Internal speakers, and projector startup Chime.
Sources: allows you to assign a particular input to a specific source key when using the Integrator remote. Also allows selection of a default Startup Source and enables or disables Autosource.
Sources>Autosource: When Autosource is not checked, the projector defaults to the source selected in Powerup Source. If no source is found, a blank screen displays. When Autosource is checked, Powerup Source deter- mines which source the projector defaults to at
System>Rear: reverses the image so you can project from behind a translucent screen.
Ceiling: turns the image upside down for
IR Receivers: turns individual IR receivers off or on to avoid environ- mental interference.
Auto Power: When Auto Power is checked, the projector automatically goes into the startup state after the projector is powered on. This allows control of ceiling mounted projectors with a wall power switch.
Display Messages: displays status messages (such as “Searching” or “Mute”) in the
Low Power: toggles between on and off. Turn it on to lower the light out- put of the lamp. This also lowers the fan speed, making the projector qui- eter.
NND: prevents your notebook computer from going into Screen Save mode (functions only when the USB connector is plugged in).
Power Save: automatically turns the lamp off after no signals are detected for 20 minutes. After 10 additional minutes with no signal, the projector powers down. If an active signal is received before the projec- tor powers down, the image will be displayed.
Settings |
|
menu | Audio |
|
Sources | Powerup |
| Source |
IR Receivers
System | IR Receivers |
35